Related papers: Implementation of linear detection techniques to o…
Reconfigurable intelligent surface is a potential technology component of future wireless networks due to its capability of shaping the wireless environment. The promising MIMO systems in terms of extended coverage and enhanced capacity…
Millimeter-wave massive MIMO with lens antenna array can considerably reduce the number of required radio-frequency (RF) chains by beam selection. However, beam selection requires the base station to acquire the accurate information of…
We present an analytical, simulation, and experimental-based study of beamforming Multiple Input Single Output (MISO) systems. We analyze the performance of beamforming MISO systems taking into account implementation complexity and effects…
The spatial Sigma-Delta ($\Sigma\Delta$) architecture can be leveraged to reduce the quantization noise and enhance the effective resolution of few-bit analog-to-digital converters (ADCs) at certain spatial frequencies of interest.…
In this work, salient characteristics of a wireless communication system deploying a great number of antennas in the base station (BS), namely Massive MIMO system, are investigated. In particular, we found a simple and meaningful…
We investigate quantization and feedback of channel state information in a multiuser (MU) multiple input multiple output (MIMO) system. Each user may receive multiple data streams. Our design minimizes the sum mean squared error (SMSE)…
The premise of massive multiple-input multiple-output (MIMO) is based around coherent transmission and detection. Majority of the vast literature on massive MIMO presents performance evaluations over simplified statistical propagation…
In this paper, we present a non-coherent energy detection scheme for spatial modulation (SM) systems. In particular, the use of SM is motivated by its low-complexity implementation in comparison to multiple-input multiple-output (MIMO)…
We propose enhancements to score-based generative modeling techniques for low-latency pilot-based channel estimation in a point-to-point single-carrier multiple-input multiple-output (MIMO) wireless system. Building on recent advances in…
Multi-antenna or multiple-input multiple-output (MIMO) technique can significantly improve the efficiency of radio frequency (RF) signal enabled wireless energy transfer (WET). To fully exploit the energy beamforming gain at the energy…
This paper addresses the problem of estimating sparse channels in massive MIMO-OFDM systems. Most wireless channels are sparse in nature with large delay spread. In addition, these channels as observed by multiple antennas in a neighborhood…
The use of large-scale antenna arrays has the potential to bring substantial improvements in energy efficiency and/or spectral efficiency to future wireless systems, due to the greatly improved spatial beamforming resolution. Recent…
Channel estimation is fundamental to wireless communications, yet it becomes increasingly challenging in massive multiple-input multiple-output (MIMO) systems where base stations employ hundreds of antennas. Traditional least-squares…
Multiple-input multiple-output (MIMO) system is the key technology for long term evolution (LTE) and 5G. The information detection problem at the receiver side is in general difficult due to the imbalance of decoding complexity and decoding…
The problem of MIMO channel estimation at millimeter wave frequencies, both in a single-user and in a multi-user setting, is tackled in this paper. Using a subspace approach, we develop a protocol enabling the estimation of the right (resp.…
We consider a downlink 1-bit quantized multiuser (MU) multiple-input-multiple-output (MIMO) system, where 1-bit digital-to-analog (DACs) and analog-to-digital converters (ADCs) are used at the transmitter and the receiver for economical and…
We analyze the mean-squared error (MSE) performance of widely linear (WL) and conventional subspace-based channel estimation for single-input multiple-output (SIMO) flat-fading channels employing binary phase-shift-keying (BPSK) modulation…
Practical multiple-input-multiple-output (MIMO) systems depend on a predefined set of precoders to provide spatial multiplexing gain. This limitation on the flexibility of the precoders affects the overall performance. Here, we propose a…
The use of large-scale antenna arrays can bring substantial improvements in energy and/or spectral efficiency to wireless systems due to the greatly improved spatial resolution and array gain. Recent works in the field of massive…
Emerging technologies, such as holographic multiple-input multiple-output (HMIMO) and stacked intelligent metasurface (SIM), are driving the development of wireless communication systems. Specifically, the SIM is physically constructed by…