Related papers: Effects of flake size on mode-locking behavior for…
Semiconductor lasers in use today rely on mirrors based on the reflection at a cleaved facet or Bragg reflection from a periodic stack of layers. Here, we demonstrate an ultra-small laser with a mirror based on the Fano resonance between a…
We report on the theoretical and experimental investigations of optical microcavities consisting in the plane-plane arrangement of a broadband high-reflectivity mirror and a suspended one-dimensional grating mirror possessing a high-quality…
Negative refraction of highly squeezed polaritons is a fundamental building block for nanophotonics, since it can enable many unique applications, such as deep-subwavelength imaging. However, the phenomenon of all-angle negative refraction…
We combine a graphene mode-locked oscillator with an external compressor and achieve~29fs pulses with~52mW average power. This is a simple, low-cost, and robust setup, entirely fiber based, with no free-space optics, for applications…
An electro-absorption optical modulator concept based upon a dual-graphene layer is presented. The device consists of a silicon-on-insulator waveguide upon which two graphene layers reside, separated by a thin insulating region. The lower…
In this paper, first we present a review of experimental data corresponding to phase retardation per reflection of interferential mirrors. Then, we report our new measurements on both commercial and tailor-made mirrors. To be able to…
We report a switchable time-varying mirror, composed of an ITO-Au stack, which can be efficiently modulated in time with over a ten-fold increase in reflectivity, with a change of 0.6. Upon interacting with the time-varying mirror, the…
We demonstrate mode-locking of a thulium-doped fiber laser operating at 1.94\mu m, using a graphene-based saturable absorber. The laser outputs 3.6ps pulses, with~0.4nJ energy and an amplitude fluctuation~0.5%, at 6.46MHz. This is a simple,…
A wavelength spacing tunable, multiwavelength Q-switched mode-locked (QML) fiber laser in an erbium-doped fiber cavity based on graphene oxide deposited on tapered fiber is proposed by choosing the diameter and length of the taper, graphene…
In connection with the experiments recently achieved on doped crystals, biological samples, doped optical fibers and semiconductor heterostructures, we revisit the theory of the propagation of a pulse-modulated light in a saturable…
In nanofabrication, just as in any other craft, the scale of spatial details is limited by the dimensions of the tool at hand. For example, the smallest details for direct laser writing with far-field light are set by the diffraction limit,…
We investigate advanced CMOS-compatible Graphene/Silicon active metasurfaces based on guided-mode resonance filters. The simulated results show a high extinction ratio (>25 dB), narrow linewidth (~1.5 nm @1550 nm), quality factor of Q~1000,…
Flying plasma mirrors induced by intense lasers has been proposed as a promising way to generate few-cycle EUV or X-ray lasers. In addition, if such a relativistic plasma mirror can accelerate, then it would serve as an analog black hole to…
We show that a passive dispersive reflector integrated into a semiconductor laser can be used to tailor the laser dynamics for the generation of ultrashort pulses as well as stable dual-mode lasing. We analyze the stability using a general…
The optical absorption properties of graphene wrapped dielectric particles have been investigated by using Mie scattering theory and exact multi-scattering method. It is shown that subwavelength strong absorption in infrared spectra can…
Filters typically play a crucial role in generating solitons by strictly confirming the working wavelength in a mode-locked laser. However, we have found that the broad smoothing filter with saturable gain also helps to regulate the pulses'…
We present the design and prototype of a switchable electron mirror, along with a technique for driving it with a flat-top pulse. We employ a general technique for electronic pulse-shaping, where high fidelity of the pulse shape is required…
Atomic Force Microscopy (AFM) in the tapping (intermittent contact) mode is a commonly used tool to measure the thickness of graphene and few layer graphene (FLG) flakes on silicon oxide surfaces. It is a convenient tool to quickly…
Carbon fibre composite technology for lightweight mirrors is gaining increasing interest in the space- and ground-based astronomical communities for its low weight, ease of manufacturing, excellent thermal qualities and robustness. We…
Exploring novel materials with enhanced optical nonlinearities at low power levels with ultrafast response and small footprints is of great interests for information processing, communication, sensing and quantum systems. Recent progress on…