Related papers: Modulation-Specific Multiuser Transmit Precoding a…
Integrated sensing and communication (ISAC) has been recognized as one of the key technologies capable of simultaneously improving communication and sensing services in future wireless networks. Moreover, the introduction of recently…
This paper proposes a joint design of probabilistic constellation shaping (PCS) and precoding to enhance the sum-rate performance of multi-user visible light communications (VLC) broadcast channels subject to signal amplitude constraint. In…
The present work focuses on the forward link of a broadband multibeam satellite system that aggressively reuses the user link frequency resources. Two fundamental practical challenges, namely the need to frame multiple users per…
We propose a downlink beamforming scheme that combines spatial division and orthogonal space-time block coding (OSTBC) in multi-user massive MIMO systems. The beamformer is divided into two parts: a pre-beamforming matrix to separate the…
The idea of media-based modulation (MBM) is to embed information in the channel states via intentional perturbations of the transmission media. This article covers a broad range of topics regarding MBM, expanding on its benefits and…
Quantized massive multiple-input-multiple-output (MIMO) systems are gaining more interest due to their power efficiency. We present a new precoding technique to mitigate the multi-user interference and the quantization distortions in a…
Sensor-aided beamforming reduces the overheads associated with beam training in millimeter-wave (mmWave) multi-input-multi-output (MIMO) communication systems. Most prior work, though, neglects the challenges associated with establishing…
This paper addresses the joint transceiver design for downlink multiuser multiple-input multiple-output (MIMO) systems, with imperfect channel state information (CSI) at the base station (BS) and mobile stations (MSs). By incorporating…
This paper focuses on multi-user downlink signal transmission in a wireless system aided by multiple reconfigurable intelligent surfaces (RISs). In such a multi-RIS, multi-user, multi-antenna scenario, determining a set of RIS phase shifts…
Spatial multiplexing (SMX) multiple-input multiple-output (MIMO) over the best beamspace was considered as the best solution for millimeter wave (mmWave) communications regarding spectral efficiency (SE), referred as the best beamspace…
For extensive coverage areas, multi-beam high throughput satellite (MB-HTS) communication is a promising technology that plays a crucial role in delivering broadband services to many users with diverse Quality of Service (QoS) requirements.…
We consider a massive MU-MIMO downlink time-division duplex system where a base station (BS) equipped with many antennas serves several single-antenna users in the same time-frequency resource. We assume that the BS uses linear precoding…
In this paper, we propose a multi-input multi-output transmit beamforming optimization model for joint radar sensing and multi-user communications, where the design of the beamformers is formulated as an optimization problem whose objective…
In a recent work, a capacity-achieving scheme for the common-message two-user MIMO broadcast channel, based on single-stream coding and decoding, was described. This was obtained via a novel joint unitary triangularization which is applied…
This letter investigates the hybrid analog and digital beamforming (HBF) design for multiuser millimeter wave (mmWave) communication systems based on the minimum mean square error (MMSE) criterion. Using the alternating minimization method,…
The deployment of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems cannot rely solely on digital precoding due to hardware constraints. Instead, hybrid precoding, which combines digital and radio frequency (RF)…
In magnetic resonant coupling (MRC) enabled multiple-input multiple-output (MIMO) wireless power transfer (WPT) systems, multiple transmitters (TXs) each with one single coil are used to enhance the efficiency of simultaneous power transfer…
The next generation of wireless communications systems will employ new frequency bands such as those in the upper midband, millimeter-wave and sub-terahertz frequency bands. The high energy consumption of analog-to-digital converters…
Antenna arrays will be an important ingredient in millimeter wave (mmWave) cellular systems. A natural application of antenna arrays is simultaneous transmission to multiple users. Unfortunately, the hardware constraints in mmWave systems…
In multi-user communication from one base station (BS) to multiple users, the problem of minimizing the transmit power to achieve some target guaranteed performance (rates) at users has been well investigated in the literature. Similarly…