Related papers: On the Spectral Efficiency of Space-Constrained Ma…
This paper studies the capacity of a general multiple-input multiple-output (MIMO) free-space optical intensity channel under a per-input-antenna peak-power constraint and a total average-power constraint over all input antennas. The focus…
In this paper, we present a non-coherent energy detection scheme for spatial modulation (SM) systems. In particular, the use of SM is motivated by its low-complexity implementation in comparison to multiple-input multiple-output (MIMO)…
Multiple-input multiple-output has been a key technology for wireless systems for decades. For typical MIMO communication systems, antenna array elements are usually separated by half of the carrier wavelength, thus termed as conventional…
In this paper, delay constrained performance of a multiple-input multiple-output (MIMO) communication system in a dense environment with co-channel interference is investigated. We apply orthogonal space-time block coding (OSTBC) at the…
To improve the cellular energy efficiency, without sacrificing quality-of-service (QoS) at the users, the network topology must be densified to enable higher spatial reuse. We analyze a combination of two densification approaches, namely…
In this letter, we proposed a shared-antenna full-duplex massive MIMO model for the multiuser MIMO system. This model exploits a single antenna array at the base station (BS) to transmit and receive the signals simultaneously. It has the…
Contemporary wireless communication systems rely on Multi-User Multiple-Input Multiple-Output (MU-MIMO) techniques. In such systems, each Access Point (AP) is equipped with multiple antenna elements and serves multiple devices…
Consider a MIMO interference channel whereby each transmitter and receiver are equipped with multiple antennas. The basic problem is to design optimal linear transceivers (or beamformers) that can maximize system throughput. The recent work…
We study how dense multi-antenna millimeter wave (mmWave) cellular network performance scales in terms of the base station (BS) spatial density $\lambda$, by studying the signal-to-interference-plus-noise ratio (SINR) and the area spectral…
We consider a multi-pair massive multiple-input multiple-output (MIMO) relay network, where the relay is equipped with a large number, N, of antennas, but driven by a far smaller number, L, of radio frequency (RF) chains. We assume that K…
In the development of wireless communication technology, multiple-input multiple-output (MIMO) technology has emerged as a key enabler, significantly enhancing the capacity of communication systems. However, traditional MIMO systems, which…
Future cellular systems based on the use of millimeter waves will heavily rely on the use of antenna arrays both at the transmitter and at the receiver. For complexity reasons and energy consumption issues, fully digital precoding and…
An asymptotic technique is developed to find the Signal-to-Interference-plus-Noise-Ratio (SINR) and spectral efficiency of a link with N receiver antennas in wireless networks with non-homogeneous distributions of nodes. It is found that…
The emergence of reconfigurable intelligent surfaces (RISs) enables us to establish programmable radio wave propagation that caters for wireless communications, via employing low-cost passive reflecting units. This work studies the…
Cell-free massive MIMO (CF-mMIMO) provides wireless connectivity for a large number of user equipments (UEs) using access points (APs) distributed across a wide area with high spectral efficiency (SE). The energy efficiency (EE) of the…
Rate-splitting (RS) has recently been recognized as a promising physical-layer technique for multi-antenna broadcast channels (BC). Due to its ability to partially decode the interference and partially treat the remaining interference as…
We investigate the capacity scaling of MIMO systems with the system dimensions. To that end, we quantify how the mutual information varies when the number of antennas (at either the receiver or transmitter side) is altered. For a system…
Integrating cell-free massive multiple-input multiple-output (MIMO) with simultaneous transmitting and reflecting reconfigurable intelligent surfaces (STAR-RISs) can provide ubiquitous connectivity and enhance coverage. This paper explores…
Massive multiple-input multiple-output (MIMO) and full-duplex (FD) are promising candidates for achieving the spectral efficiency to meet the needs of 5G communications. One essential key to realizing practical FD massive MIMO systems is…
Grant-free random access (RA) with massive MIMO is a promising RA technique for massive access with low signaling overhead. In the grant-free RA with massive MIMO, preamble length has a critical impact on the performance of the system. In…