Related papers: Boiling crisis and non-equilibrium drying transiti…
Spray cooling a hot target is characterized by strong heat flux density and fast change of the temperature of the wall interface. The heat flux density during spray cooling is determined by the instantaneous substrate temperature, which is…
Phase transformations such as freezing typically start with heterogeneous nucleation. Heterogeneous nucleation near a wetting transition, of a crystalline phase is studied. The wetting transition occurs at or near a vapour-liquid transition…
We show that phase separation can occur in a one-component liquid outside its coexistence curve (CX) with addition of a small amount of a solute. The solute concentration at the transition decreases with increasing the difference of the…
The evaporation of vapor bubbles inside a microchannel is important to realize a device with high cooling performance. The liquid film formed on the solid surface is essential for evaporative heat transfer from solid to fluid; its formation…
What is the interface temperature during phase transition (for instance, from liquid to vapor)? This question remains fundamentally unresolved. In the modeling of heat transfer problems with no phase change, the temperature and heat flux…
Vapor bubbles are formed in liquids by two mechanisms: evaporation (temperature above the boiling threshold) and cavitation (pressure below the vapor pressure). The liquid resists in these metastable (overheating and tensile, respectively)…
A fundamental problem of glass transition is to explain the jump of heat capacity at the glass transition temperature $T_g$ without asserting the existence of a distinct solid glass phase. This problem is also common to other disordered…
Boiling heat transfer is the basis of many commonly used cooling techniques. In cooling of electronic devices, for example, it is desirable to further miniaturize heat exchangers to achieve higher heat transfer, and thus it is necessary to…
Droplets impacting on a superheated surface can either exhibit a contact boiling regime, in which they make direct contact with the surface and boil violently, or a film boiling regime, in which they remain separated from the surface by…
A hybrid thermal lattice Boltzmann phase-change model was performed to simulate the pool boiling above a smooth horizontal heater. The effects of homogenous and heterogeneous wettability on entire boiling curves from the onset of nucleate…
Joule heat generated by resistive elements of cryogenic micro- and nanodevices often originates boiling of the cooling cryogenic liquids (helium, nitrogen). The article proposes an experimental method to explore the dynamics of the…
The dynamics of the triple gas-liquid-solid contact line is analysed for the case where the gas is the saturated vapour corresponding to the liquid, like in the vapour bubble in boiling. It is shown that even small superheating (with…
Above a critical temperature known as the Leidenfrost point (LFP), a heated surface can suspend a liquid droplet above a film of its own vapor. The insulating vapor film can be highly detrimental in metallurgical quenching and thermal…
The study of vapor bubble growth following droplet vaporization in a superheated liquid involves research areas such as hydrodynamics, heat transfer, mass transfer, and thermodynamics. The interplay between these multiscale aspects is…
Heat conduction phenomena are studied theoretically using computer simulation. The systems are crystal with nonlinear interaction, and fluid of hard-core particles. Quasi-one-dimensional system of the size of $L_x\times L_y\times L_z(L_z\gg…
Both experimental and theoretical studies on the microscale and fast physical phenomena occurring during the growth of vapor bubbles in nucleate pool boiling are reported. The focus is on the liquid film of micrometric thickness…
We report that liquids perform self-propelled motion when they are placed in contact with hot surfaces with asymmetric (ratchet-like) topology. The pumping effect is observed when the liquid is in the film-boiling regime, for many liquids…
Kinetic theory has long predicted that temperature inversion may happen in the vapor-phase for evaporation and condensation between two parallel plates, i.e., the vapor temperature at the condensation interface is higher than that at the…
The neutron star starts to cool down shortly after its birth by emitting neutrinos. As it becomes cold enough, the Cooper pairs of neutrons are formed, triggering a superfluid transition. Previous studies on neutron superfluidity focused on…
Non-equilibrium critical phenomena generally exist in many dynamic systems, like chemical reactions and some driven-dissipative {reactive} particle systems. Here, by using computer simulation and theoretical analysis, we demonstrate the…