Related papers: Using a double-frequency RF system to facilitate o…
We suggest a new on-axis injection scheme that uses two deflecting cavities to remove the tilt of the stored beam, and to kick the injected beam into the ring. In this new injection scheme, an injected beam with a certain angle is overlaid…
The multi-bunch injection has been adopt at SSRF which greatly increases the injection rate and reduces injection time compared to the single bunch injection. The multi-bunch injection will massively reduce the beam failure time during…
The Storage Ring at the Advanced Light Source is capable of being filled in selectable buckets. Typically, 276 consecutive buckets out of 328 possible are selected. It has been found that the amount of charge injected is not uniform…
To make full use of photocathode material and improve its quantum efficiency lifetime, it can be necessary to operate laser away from the cathode center in photoinjectors. In RF guns, the off-axis emitted beam will see a time-dependent RF…
In the fourth-generation storage ring light sources (4GLSs), associated with the extremely strong nonlinearities inherent in the multi-bend achromat design, the dynamic acceptance is usually small and it is difficult to implement…
A new beam injection scheme is proposed for the Fermilab Booster to increase beam brightness. The beam is injected on the deceleration part of the sinusoidal magnetic ramp and capture is started immediately after the injection. During the…
Recirculating energy recovery linacs are a promising technology for delivering high power particle beams ($\sim$GW) while only requiring low power ($\sim$kW) RF sources. This is achieved by decelerating the used bunches and using the energy…
The ALS-U light source will implement on-axis single-train swap-out injection employing an accumulator between the booster and storage rings. The accumulator ring design is a twelve period triple-bend achromat that will be installed along…
Radio-frequency (RF) systems deliver the power to change the energy of a charged particle beam, and they are integral parts of linear and circular accelerators. A longitudinal electrical field in the direction of the beam is generated in a…
Two barrier RF systems were fabricated, tested and installed in the Fermilab Main Injector. Each can provide 8 kV rectangular pulses (the RF barriers) at 90 kHz. When a stationary barrier is combined with a moving barrier, injected beams…
This paper introduces a new method for stacking beams in the longitudinal phase space. It uses RF barriers to confine and compress beams in an accelerator, provided that the machine momentum acceptance is a few times larger than the…
Battery energy storage systems (BESSs) can play a key role in mitigating the intermittency and uncertainty associated with adding large amounts of renewable energy to the bulk power system (BPS). Two BESS technologies that have gained…
A new accelerator complex, HIAF (the High Intensity Heavy Ion Accelerator Facility), has been approved in China. It is designed to provide intense primary and radioactive ion beams for research in high energy density physics, nuclear…
Three-dimensional spiral injection enables beam storage in ultra-compact rings with nanosecond revolution periods. We report first storage of a $297 \, \mathrm{keV/}c$ electron beam in a $22 \,\mathrm{cm}$ weak-focusing ring with a…
We report on an injection feedback scheme for the ThomX storage ring project. ThomX is a 50-MeV-electron accelerator prototype which will use Compton backscattering in a storage ring to generate a high flux of hard X-rays. Given the slow…
High luminosity in DAFNE needs very high electron and positron currents stored. A full energy (510 MeV) injection system composed by a full energy electron and positron linac and an accumulator-damping ring is presently used. The electron…
In order to double the positron injection rate into the KEKB ring, a two-bunch acceleration scheme has been studied at the linac, in which bunches separated by 96 ns are accelerated in 50 Hz. In this scheme the stabilization of energy and…
High harmonic cavities are widely used in electron storage rings to lengthen the bunch, thereby enhancing the Touschek lifetime, reducing the IBS effect, as well as providing Landau damping. When the RF phase is modulated in such a dual-RF…
A review of electron beam bunching methods and new bunching methods are presented. Linear accelerator, storage ring and buncher technologies offer high-beam quality and short bunches necessary for operation of high efficiency, high-power,…
Injection performance of storage ring is one of the important factors for the light efficiency and quality of Synchrotron Radiation Facility when it is in top-up mode. To evaluate the injection performance of storage ring at SSRF, we build…