Related papers: Analytical Heat Transfer Modeling of a New Radiati…
A calorimetric detector for minimally disruptive measurements of atomic hydrogen beams is described. The calorimeter measures heat released by the recombination of hydrogen atoms into molecules on a thin wire. As a demonstration, the…
Every time a chemical reaction occurs, an energy exchange between reactants and environment exists, which is defined as the enthalpy of the reaction. In the last decades, research has resulted in an increasing number of devices at the…
In the described device, the thermal emissivity or absorptivity of the sample is measured by substitution of the radiative heat flow between two parallel surfaces by thermal output of a heater. Fast measurements of the mutual emissivity for…
This paper presents a comprehensive computer simulation of thermal processes in multilayered biological tissues for the analysis of luminance temperature distributions recorded by microwave radiometry. A mathematical model combining the…
A differential, membrane-based nanocalorimeter for general specific heat studies of very small samples, ranging from 0.5 mg to sub-{\mu}g in mass, is described. The calorimeter operates over the temperature range from above room temperature…
Operando calorimetry has previously been utilized to study degradation, side reactions, and other electrochemical effects in electrochemical cells such as batteries at or near room temperature. Calorimetric data can provide important…
Recent developments of the AC-calorimetric technique adapted for the needs of high pressure experiments are discussed. A semi-quantitative measurement of the specific heat with a Bridgman-type of pressure cell as well as a diamond anvil…
Membrane based nanocalorimeters have been developed for ac calorimetry experiments. It has allowed highly sensitive measurements of heat capacity from solid state physics to complex systems like polymers and proteins. In this article we…
We have developed a new calorimeter for measuring thermodynamic properties in pulsed magnetic fields. An instrumental design is described along with the construction details including the sensitivity of a RuO2 thermometer. The operation of…
We report a model-based method for quantifying heat flow and storage in thermal systems using data from multiple thermal sensors. This approach avoids stringent requirements on the system geometry and sensor positions and enables…
The recent development of a scanning thermal microscope (SThM) has led to measurements of radiative heat transfer between a heated sensor and a cooled sample down to the nanometer range. This allows for comparision of the known theoretical…
Thermal emission is the radiation of electromagnetic waves from hot objects. The promise of thermal-emission engineering for applications in energy harvesting, radiative cooling, and thermal camouflage has recently led to renewed research…
We present a method for the measurement of a temperature differential across a single quantum dot that has transmission resonances that are separated in energy by much more than the thermal energy. We determine numerically that the method…
In this paper, we describe ongoing work to investigate the properties of the heat spreader, and its implication on architecture research. In specific, we conduct two experiments to quantify the heat distribution across the surface of a…
We describe a compact calorimeter that opens ultra-low temperature heat capacity studies of small metal crystals in moderate magnetic fields. The performance is demonstrated on the canonical heavy Fermion metal YbRh2Si2. Thermometry is…
We provide the theoretical basis of calorimetry for a class of active particles subject to thermal noise. Simulating AC-calorimetry, we numerically evaluate the heat capacity of run-and-tumble particles in double-well and in periodic…
An equation based reduced order model applicable to generalized heat equation and thermal simulations of power electronics systems developed in commercial CFD tools, is presented in this work. The model considers the physics of heat…
In nuclear, particle and astroparticle physics experiments, calorimeters are used to measure the properties of particles with kinetic energies that range from a fraction of 1 eV to 10^20 eV or more. These properties are not necessarily…
Predictive flame spread models based on temperature dependent pyrolysis rates require numerous material properties as input parameters. These parameters are typically derived by optimisation and inverse modelling using data from bench scale…
Temperature estimation, known as thermometry, is a critical sensing task for physical systems operating in the quantum regime. Indeed, thermal fluctuations can significantly degrade quantum coherence. Therefore, accurately determining the…