Related papers: Devices for high precision x-ray beam intensity mo…
A single channel, high precision ionization chamber has been built for monitoring the relative intensity of X-rays in the energy range above 5 keV. It can be used in experiments, such as EXAFS, where simultaneous high precision monitoring…
BPM (Beam Position Measurement) system is one of the most important beam diagnostic instruments in accelerators. A fully digital BPM (DBPM) has been designed for SSRF (Shanghai Synchrotron Radiation Facility). As Analog-to-Digital Converter…
Three ultra-short-period W/B4C multilayers (1.244nm, 1.235nm and 1.034nm) have been fabricated and used for polarization measurement at the 4B7B Beamline of Beijing Synchrotron Radiation Facility (BSRF). By rotating analyzer ellipsometry…
We consider different approaches to simulate a modern X-ray beamline. Several methodologies with increasing complexity are applied to discuss the relevant parameters that quantify the beamline performance. Parameters such as flux,…
Synchrotron radiation facilities provide highly polarized X-ray beams across a wide energy range. However, the exact type and degree of polarization varies according to the beamline and experimental setup. To accurately determine the angle…
We report the design and test results of a beam monitor developed for online monitoring in hadron therapy. The beam monitor uses eight silicon pixel sensors, \textit{Topmetal-${II}^-$}, as the anode array. \textit{Topmetal-${II}^-$} is a…
One-dimensional single-wire chamber was developed to provide high position resolution for powder diffraction experiments with synchrotron radiation. A diffraction test using the sample of SiO2 has been accomplished at 1W2B laboratory of…
A method is proposed for deriving the dispersion measure (related to the line-of-sight integrated free electron density) to high-redshift, powerful synchrotron radio sources by analysis of the temporal/spectral properties of the recorded…
The development of synchrotron radiation light sources has been going on for decades. Recently, X-ray free-electron lasers as well as the fourth-generation synchrotron radiation sources based on multiple bend achromat lattices are…
Medical synchrotrons are often used for testing instrumentation in high-energy physics or non-clinical research in medical physics. In many applications of medical synchrotrons, such as microdosimetry and ion imaging, precise knowledge of…
Synchrotron radiation has been used for many years as a beam diagnostic at electron accelerators. It is not normally associated with proton accelerators as the intensity of the radiation is too weak to make detection practical. However, if…
On-line monitoring of beam quality for high brightness beams is only possible using non-invasive instruments. For matching measurements, very few such instruments are available. One candidate is a quadrupole pick-up. Therefore, a new type…
Fast ion instability has been observed in the early commissioning and operation of the Shanghai Synchrotron Radiation Facility (SSRF) storage ring. In this paper, a weak-strong code is used to simulate the fast ion instability in SSRF…
The large majority of BL Lacertae objects belonging to the 1 Jy sample, the class prototype for radio-selected sources, are thought to emit most of their synchrotron power in the far IR band. Ironically, this spectral region is very…
It is important to have experimental methods to estimate the maximum beam intensity for the Fermilab Booster as objective input into long term program commitments. An important existing limit is set by the available rf power. This limit is…
Plasma scattering measurement is effective technique to observe low frequency density fluctuations excited in plasma. The spatial and wave number resolutions and the S/N ratio of measurement depend on the wavelength range, the size and the…
The ion composition of dual-species beams in synchrotrons is typically inferred from invasive measurements performed after beam extraction. This paper introduces a complementary noninvasive method to determine the ion composition of such…
The development of instrumentation to be operated in high-radiation environments is one of the main challenges in fundamental research. Besides space and nuclear applications, particle physics experiments also need radiation-hard devices.…
Ionization chambers are essential for activity determinations in radionuclide metrology. We have developed a high-precision integrating-differentiating (int-diff) system for measuring small currents. It is anticipated to enhance the…
High-brightness X-ray pulses, as generated at synchrotrons and X-ray free electron lasers (XFEL), are used in a variety of scientific experiments. Many experimental testbeds require optical equipment, e.g Compound Refractive Lenses (CRLs),…