Related papers: Distributed Energy Beamforming with One-Bit Feedba…
Energy beamforming (EB) is a key technique for achieving efficient radio-frequency (RF) transmission enabled wireless energy transfer (WET). By optimally designing the waveforms from multiple energy transmitters (ETs) over the wireless…
Wireless energy transfer (WET) has attracted significant attention recently for providing energy supplies wirelessly to electrical devices without the need of wires or cables. Among different types of WET techniques, the radio frequency…
Multiple antenna techniques, that allow energy beamforming, have been looked upon as a possible candidate for increasing the efficiency of the transfer process between the energy transmitter (ET) and the energy receiver (ER) in wireless…
We study RF-enabled wireless energy transfer (WET) via energy beamforming, from a multi-antenna energy transmitter (ET) to multiple energy receivers (ERs) in a backscatter communication system, such as RFID, where each ER (or RFID tag)…
To reap the active and passive beamforming gain in an intelligent reflecting surface (IRS)-aided wireless network, a typical way is to first acquire the channel state information (CSI) relying on the pilot signal, and then perform the joint…
Radio-frequency (RF) enabled wireless energy transfer (WET), as a promising solution to provide cost-effective and reliable power supplies for energy-constrained wireless networks, has drawn growing interests recently. To overcome the…
Multiple antenna techniques that allow energy beamforming have been looked upon as a possible candidate for increasing the transfer efficiency between the energy transmitter (ET) and the energy receiver (ER) in wireless power transfer. This…
This paper proposes a novel channel estimation method, and a cluster-based opportunistic scheduling policy, that enhances the efficiency of wireless energy transfer in a system consisting of multiple energy receivers (ERs). Firstly, in the…
Waveform design is a key technique to jointly exploit a beamforming gain, the channel frequency-selectivity and the rectifier nonlinearity, so as to enhance the end-to-end power transfer efficiency of Wireless Power Transfer (WPT). Those…
This paper studies the optimal training design for a multiple-input single-output (MISO) wireless energy transfer (WET) system in frequency-selective channels, where the frequency-diversity and energy-beamforming gains can be both achieved…
Multi-antenna or multiple-input multiple-output (MIMO) technique can significantly improve the efficiency of radio frequency (RF) signal enabled wireless energy transfer (WET). To fully exploit the energy beamforming gain at the energy…
This paper focuses on wireless energy transfer (WET) to a pair of low complex energy receivers (ER), by only utilizing received signal strength indicator (RSSI) values that are fed back from the ERs to the energy transmitter (ET). Selecting…
This paper studies the training design problem for multiple-input single-output (MISO) wireless energy transfer (WET) systems in frequency-selective channels, where the frequency-diversity and energy-beamforming gains can be both reaped to…
Radio frequency (RF) wireless power transfer (WPT) is a promising technology for charging the Internet of Things. Practical RF-WPT systems usually require energy beamforming (EB), which can compensate for the severe propagation loss by…
Energy beamforming (EB) is a key technique to enhance the efficiency of wireless power transfer (WPT). In this paper, we study the optimal EB under per-antenna power constraint (PAC) which is more practical than the conventional sum-power…
Energy beamforming has emerged as a promising technique for enhancing the energy transfer efficiency of wireless power transfer (WPT). However, the performance of conventional energy beamforming may seriously degrade due to the non-linear…
This paper proposes a novel channel estimation method and a cluster-based opportunistic scheduling policy, for a wireless energy transfer (WET) system consisting of multiple low-complex energy receivers (ERs) with limited processing…
This letter studies a radio-frequency (RF) multi-user wireless power transfer (WPT) system, where an energy transmitter (ET) with a large number of antennas delivers energy wirelessly to multiple distributed energy receivers (ERs). We…
A simple feedback control algorithm is presented for distributed beamforming in a wireless network. A network of wireless sensors that seek to cooperatively transmit a common message signal to a Base Station (BS) is considered. In this…
Wirelessly powered backscatter communication (WPBC) has been identified as a promising technology for low-power communication systems, which can reap the benefits of energy beamforming to improve energy transfer efficiency. Existing studies…