Related papers: Nonlinear parametric amplification in a tri-port n…
Flexoelectricity is a property of all dielectric materials, where inhomogeneous strain induces electrical polarization. This effect becomes particularly prominent at the nanoscale where larger strain gradients can be obtained. While…
Detection of the weakest forces in nature and the search for new physics are aided by increasingly sensitive measurements of the motion of mechanical oscillators. However, the attainable knowledge of an oscillator's motion is limited by…
Theory of the optical parametric amplification at high-frequency pumping in crystals with a regular space modulation of the sign of nonlinear coupling coefficient of interacting waves is developed. By applying the matrix method, the theory…
Incremental stiffness characterizes the variation of a material's force response to a small deformation change. Typically materials have an incremental stiffness that is fixed and positive, but recent technologies, such as super-lenses, low…
Parametric converters are parametric amplifiers that mix two spatially separate nondegenerate modes and are commonly used for amplifying and squeezing microwave signals in quantum computing and sensing. In Josephson parametric converters,…
We observe parametric amplification of electromagnetic (EM) waves produced by a flux-flow oscillator made of YBa2Cu3O7 Josephson junctions arrays coupled to the resonant modes of a millimeter wave Fabry-Perot resonator at a pump frequency…
A simulation of an atomic force microscope operating in the constant amplitude dynamic mode is described. The implementation mimics the electronics of a real setup including a digital phase-locked loop (PLL). The PLL is not only used as a…
An ongoing challenge in atomic force microscope (AFM) experiments is the quantitative measurement of cantilever motion. The vast majority of AFMs use the optical beam deflection (OBD) method to infer the deflection of the cantilever. The…
Recently, a non-thermal excess noise, compatible with the theoretical prediction provided by collapse models, was measured in a millikelvin nanomechanical cantilever experiment [Vinante et al., Phys. Rev. Lett. 119, 110401 (2017)]. We…
We present a simple technique to produce active Q-switching in various types of fiber amplifiers by active integration of an electrostatic actuated deformable metallic micro-mirror. The optical MEMS (MOEMS) device acts as one of the laser…
We derive analytic solutions for Heisenberg evolution under the trilinear parametric Hamiltonian which are correct to second order in the interaction strength but are valid for all pump amplitudes. The solutions allow pump depletion effects…
We describe a transducer for low-temperature atomic force microscopy based on electromechanical coupling due to a strain-dependent kinetic inductance of a superconducting nanowire. The force sensor is a bending triangular plate (cantilever)…
An open question in mechanics is whether mechanical resonators can be made nonlinear with vibrations approaching the quantum ground state. This requires engineering a mechanical nonlinearity far beyond what has been realized thus far. Here…
Amplification of light through stimulated emission or nonlinear optical interactions has had a transformative impact on modern science and technology. The amplification of other bosonic excitations, like phonons in solids, is likely to open…
Superconducting parametric amplifiers are commonly fabricated using planar transmission lines with a non-linear inductance provided by either Josephson junctions or the intrinsic kinetic inductance of the thin film. However, Banys et al.…
We use a reservoir engineering technique based on two-tone driving to generate and stabilize a quantum squeezed state of a micron-scale mechanical oscillator in a microwave optomechanical system. Using an independent backaction evading…
We present a microscopic theory of nonlinear damping and dephasing of low-frequency eigenmodes in nano- and micro-mechanical systems. The mechanism of the both effects is scattering of thermally excited vibrational modes off the considered…
We introduce an implementation of a non-degenerate parametric amplifier in which the signal and idler modes, respectively, a microwave mode and an ensemble of spins (e.g., nitrogen-vacancy centers in diamond), are operated in their linear…
We investigate the influence of parametric excitation on MEMS vibration energy harvesters for energy autonomous sensor systems. In Industry 4.0 (or Industrial IoT) applications, interconnected sensors provide a means of data acquisition for…
The atomic force microscope is a versatile tool that allows many routes to be used for investigating the mechanical properties of soft materials on the nanometer scale. In the present work, experiments were performed on polystyrene polymer…