Related papers: Asymptotic Performance Analysis for 1-bit Bayesian…
Typical receiver processing, targeting always the best achievable bit error rate performance, can result in a waste of resources, especially, when the transmission conditions are such that the best performance is orders of magnitude better…
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array…
One-bit quantization with time-varying sampling thresholds has recently found significant utilization potential in statistical signal processing applications due to its relatively low power consumption and low implementation cost. In…
Large-scale multiple-antenna systems have been identified as a promising technology for the next generation of wireless systems. However, by scaling up the number of receive antennas the energy consumption will also increase. One possible…
We address the issue of applying quantized compressed sensing (CS) on low-energy telemonitoring. So far, few works studied this problem in applications where signals were only approximately sparse. We propose a two-stage data compressor…
A channel with continuous phase modulation and 1-bit ADC with oversampling is considered. Due to oversampling, higher-order modulations yield a higher achievable rate and this work presents a method to approach this with sophisticated…
This paper investigates the design of analog beamforming at the receiver in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) systems, aided by full digital chains featuring 1-bit ADCs. We advocate utilizing these full digital…
This paper considers uplink massive multiple-input multiple-output (MIMO) systems with lowresolution analog-to-digital converters (ADCs) over Rician fading channels. Maximum-ratio-combining (MRC) and zero-forcing (ZF) receivers are…
Future wireless communications will rely on multiple-input multiple-output (MIMO) beamforming operating at millimeter wave (mmWave) frequency bands to deliver high data rates. To support flexible spatial processing and meet the demands of…
In Phys. Rev. A 108, L060402 (2023), we introduced a Bayesian measurement error mitigation algorithm, which leveraged complete information from the readout signal, and validated the protocol on a quantum device with five superconducting…
A spectrum- and energy-efficient system is essential for millimeter wave communication systems that require large antenna arrays with power-demanding ADCs. We propose an ADC bit allocation (BA) algorithm that solves a minimum mean squared…
Modern communication receiver architectures center around digital signal processing (DSP), with the bulk of the receiver processing being performed on digital signals obtained after analog-to-digital conversion (ADC). In this paper, we…
The one-bit quantization is implemented by one single comparator that operates at low power and a high rate. Hence one-bit compressive sensing (1bit-CS) becomes attractive in signal processing. When measurements are corrupted by noise…
High data rates require vast bandwidths, that can be found in the sub-THz band, and high sampling frequencies, which are predicted to lead to a problematically high analog-to-digital converter (ADC) power consumption. It was proposed to use…
One-bit compressed sensing is very popular in signal processing and communications due to its low storage costs and low hardware complexity, but it is a challenging task to recover the signal by using the one-bit information. In this paper,…
We present a novel iterative detection and decoding scheme for the uplink of large-scale multiuser multiple-antenna systems. In order to reduce the receiver's energy consumption and computational complexity, 1-bit analog-to-digital…
We present an adaptive smoother for linear state-space models with unknown process and measurement noise covariances. The proposed method utilizes the variational Bayes technique to perform approximate inference. The resulting smoother is…
Enabling communications in the (sub-)THz band will call for massive multiple-input multiple-output (MIMO) arrays at either the transmit- or receive-side, or at both. To scale down the complexity and power consumption when operating across…
Millimeter wave (mmWave) spectrum has drawn attention due to its tremendous available bandwidth. The high propagation losses in the mmWave bands necessitate beamforming with a large number of antennas. Traditionally each antenna is paired…
Compressed sensing is a technique for recovering a high-dimensional signal from lower-dimensional data, whose components represent partial information about the signal, utilizing prior knowledge on the sparsity of the signal. For further…