Related papers: Hybrid Analog-Digital Beamforming for Multiuser MI…
Reconfigurable holographic surfaces (RHS) are intrinsically amalgamated with reconfigurable intelligent surfaces (RIS), for beneficially ameliorating the signal propagation environment. This potent architecture significantly improves the…
Cell-free massive MIMO systems consist of many distributed access points with simple components that jointly serve the users. In millimeter wave bands, only a limited set of predetermined beams can be supported. In a network that…
This paper considers a reconfigurable intelligent surface (RIS)-aided millimeter wave (mmWave) downlink communication system where hybrid analog-digital beamforming is employed at the base station (BS). We formulate a power minimization…
Hybrid beamforming (HB) has been widely studied for reducing the number of costly radio frequency (RF) chains in massive multiple-input multiple-output (MIMO) systems. However, previous works on HB are limited to a single user equipment…
This paper conceives a hybrid beamforming design (HBF) that maximizes the energy efficiency (EE) of an integrated sensing and communication (ISAC)-enabled millimeter wave (mmWave) multiple-input multiple-output (MIMO) system. In the system…
Motivated by future automotive applications, we study some joint radar target detection and parameter estimation problems where the transmitter, equipped with a mono-static MIMO radar, wishes to detect multiple targets and then estimate…
Hybrid digital/analog architecture and low-resolution analog-to-digital/digital-to-analog converters (ADCs /DACs) are two low-cost implementations for large-scale millimeter wave (mmWave) systems. In this paper, we investigate the problem…
Antenna arrays will be an important ingredient in millimeter wave (mmWave) cellular systems. A natural application of antenna arrays is simultaneous transmission to multiple users. Unfortunately, the hardware constraints in mmWave systems…
Recently, full duplex (FD) has been studied in 5G LTE millimeter wave (mmWave) cellular communications for New Radio in 3GPP releases 15-17. FD allows bidirectional transmission over the same resources and has the potential to reduce…
Despite its promising performance gain, the realization of mmWave massive MIMO still faces several practical challenges. In particular, implementing massive MIMO in the digital domain requires hundreds of RF chains matching the number of…
We consider a multi-pair two-way amplify-and-forward massive multi-input multi-output (MIMO) hybrid relay with MIMO user-pairs. A hybrid relay has lesser number of radio frequency (RF) chains than the antennas, which significantly reduces…
This paper considers a reconfigurable intelligent surface (RIS)-aided millimeter wave (mmWave) downlink communication system where hybrid analog-digital beamforming is employed at the base station (BS). We formulate a power minimization…
Low-complexity beamformer design with practical constraints is an attractive research area for hybrid analog/digital systems in mm-wave massive multiple-input multiple-output (MIMO). This paper investigates interference-aware pre-beamformer…
Millimeter-wave (mmWave) hybrid analog-digital beamforming is a promising approach to satisfy the low-latency constraint in multiple unmanned aerial vehicles (UAVs) systems, which serve as network infrastructure for flexible deployment.…
In this paper, we investigate the optimization problem of joint source and relay beamforming matrices for a twoway amplify-and-forward (AF) multi-input multi-output (MIMO) relay system. The system consisting of two source nodes and two…
The potential of deploying large-scale antenna arrays in future wireless systems has stimulated extensive research on hybrid transceiver designs aiming to approximate the optimal fully-digital schemes with much reduced hardware cost and…
This paper develops energy-efficient hybrid beamforming designs for mmWave multi-user systems where analog precoding is realized by switches and phase shifters such that radio frequency (RF) chain to transmit antenna connections can be…
In this paper, we propose a hybrid analog-digital beamforming architecture with resolution-adaptive ADCs for millimeter wave (mmWave) receivers with large antenna arrays. We adopt array response vectors for the analog combiners and derive…
In this work, we consider the design of hybrid analog-digital (HAD) multi-carrier MIMO-OFDM two-way relaying systems, where the relay station is equipped with a HAD amplify-and-forward architecture and every mobile station is equipped with…
The high path loss associated with millimeter wave (mmWave) frequency communication can be compensated by large scale antenna arrays such as multiple-input multiple-output (MIMO) systems. The hybrid beamforming architecture which uses fewer…