Related papers: Towards Accurate Modeling of Moving Contact Lines
The conventional no-slip boundary condition leads to a non-integrable stress singularity at a moving contact line. This makes numerical simulations challenging, especially when capillary effects are essential for the dynamics of the flow.…
The conventional no-slip boundary condition leads to a non-integrable stress singularity at a contact line. This is a main challenge in numerical simulations of two-phase flows with moving contact lines. We derive a two-dimensional…
A solid-liquid-gas moving contact line is considered through a diffuse-interface model with the classical boundary condition of no-slip at the solid surface. Examination of the asymptotic behaviour as the contact line is approached shows…
The fluid-mechanics community is currently divided in assessing the boundaries of applicability of the macroscopic approach to fluid mechanical problems. Can the dynamics of nano-droplets be described by the same macroscopic equations as…
A difficulty in the classical hydrodynamic analysis of moving contact-line problems, associated with the no-slip wall boundary condition resulting in an unbalanced divergence of the viscous stresses, is reexamined with a smoothed,…
The surface of a liquid near a moving contact line is highly curved owing to diverging viscous forces. Thus, microscopic physics must be invoked at the contact line and matched to the hydrodynamic solution farther away. This matching has…
The behaviour of a solid-liquid-gas system near the three-phase contact line is considered using a diffuse-interface model with no-slip at the solid and where the fluid phase is specified by a continuous density field. Relaxation of the…
The ``no-slip'' boundary condition, i.e., zero fluid velocity relative to the solid at the fluid-solid interface, has been very successful in describing many macroscopic flows. A problem of principle arises when the no-slip boundary…
In this paper, we develop a principled method to model line and surface contact with point contact (we call this point, equivalent contact point) that is consistent with physics-based models of surface (line) contact. Assuming that the set…
The prevailing models for advancing dynamic contact angle are under intensive debates, and the fitting performances are far from satisfying in practice. The present study proposes a model based on the recent understanding of the multi-scale…
Despite decades of research, the modeling of moving contact lines has remained a formidable challenge in fluid dynamics whose resolution will impact numerous industrial, biological, and daily life applications. On the one hand, molecular…
We propose an efficient numerical method for the simulation of multi-phase flows with moving contact lines in three dimensions. The mathematical model consists of the incompressible Navier-Stokes equations for the two immiscible fluids with…
We developed a sharp interface level-set approach for two-phase immiscible flow with moving contact lines. The Cox-Voinov model is used to describe the moving contact line. A piecewise linear interface method is used to construct the signed…
The complicated dynamics of the contact line of a moving droplet on a solid substrate often hamper the efficient modeling of microfluidic systems. In particular, the selection of the effective boundary conditions, specifying the contact…
A moving contact line occurs at the intersection of an interface formed between two immiscible liquids and a solid. According to viscous theory, the flow is entirely governed by just two parameters, the viscosity ratio, $\lambda$, and the…
We study the flow close to an advancing contact line in the limit of small capillary number. To take into account wetting effects, both long and short-ranged contributions to the disjoining pressure are taken into account. In front of the…
Numerical and analytical methods are developed for the investigation of contact sets in electrostatic-elastic deflections modeling micro-electro mechanical systems. The model for the membrane deflection is a fourth-order semi-linear partial…
We present a contact mechanics problem, which we consider to be representative for contacts between nominally flat surfaces. The main ingredients of the mathematically fully defined contact problem are: Self-affine roughness, linear…
We construct gradient structures for free boundary problems with nonlinear elasticity and study the impact of moving contact lines. In this context, we numerically analyze how phase-field models converge to certain sharp-interface limits…
We consider the initial value problem for a nonlinear shallow water model in horizontal dimension d = 2 and in the presence of a fixed partially immersed solid body on the water surface. We assume that the bottom of the solid body is the…