Related papers: Compact Low-Voltage, High-Power, Multi-beam Klystr…

A large prototype of 1.3m3 was designed and built as a demonstrator of the semi-digital hadronic calorimeter (SDHCAL) concept proposed for the future ILC experiments. The prototype is a sampling hadronic calorimeter of 48 units. Each unit…

We update the search for features in the Cosmic Microwave Background (CMB) power spectrum due to transient reductions in the speed of sound, using Planck 2015 CMB temperature and polarisation data. We enlarge the parameter space to much…

The readout electronics of the ATLAS Hadronic Endcap Calorimeter (HEC) will have to withstand an about 3-5 times larger radiation environment at the future high-luminosity LHC (HLLHC) compared to their design values. The preamplifier and…

The IsoDAR collaboration is developing a high-current cyclotron for a neutrino search experiment. Designed to deliver 10 mA of 60 MeV protons, the current and power of this cyclotron far exceed those of existing accelerators, opening new…

The output of a 200 kHz, 34 W, 300 fs Yb amplifier is compressed to 31 fs with > 88 % efficiency to reach a peak power of 2.5 GW, which to date is a record for a single-stage bulk multi-pass cell. Despite operation 80 times above the…

Small-pitch 3D silicon pixel detectors have been investigated as radiation-hard candidates for the innermost layers of the HL-LHC pixel detector upgrades. Prototype 3D sensors with pixel sizes of 50$\times$50 and 25$\times$100 $\mu$m$^{2}$…

The ATLAS detector is set to undergo a substantial upgrade termed the "Phase-II" upgrade during the Long-Shutdown in preparation for the start of operation of the High Luminosity Large Hadron Collider (HL-LHC). This paper describes the…

To meet the stringent time calibration requirements for the Belle II experiment upgrade, particularly for its large-size KL and Muon Detector comprising tens of thousands of scintillator channels with time resolutions better than 100 ps, we…

In this paper, we discuss the design and whole-cavity simulation of a Multi-Beam Inductive Output Tube (MBIOT) that uses a 3rd harmonic component to the drive voltage on the grid. High-efficiency inductive output tubes (IOTs) are typically…

Forward proton spectrometers at high-energy proton colliders rely on precision timing to discriminate signal from background. Silicon low gain avalanche diodes (LGADs) are a candidate for future timing detectors in these systems. A major…

Low Gain Avalanche Detectors (LGADs) are fast silicon sensors with potential for high-resolution proton beam monitoring. In this work, we investigated their response in a 60 MeV proton beam from an AIC-144 cyclotron. Several features of the…

This document presents recent results of inclusive top-quark pair production cross section measurements at 7 and 8 TeV. The results are obtained analyzing the data collected by the CMS and ATLAS detectors at the LHC accelerator. Studies are…

Based on the design requirements proposed by the Beijing On-Line Isotope Separation project (BISOL), four Sn$^{22+}$-based,81.25MHz continuous wave (CW) drift tube linac (DTL) cavities have been designed. These DTLs are capable of…

Single air-suspended carbon nanotubes (length 2 - 5 microns) exhibit high optical quantum efficiency (7 - 20%) for resonant pumping at low intensities. Under ultrafast excitation, the photoluminescence dramatically saturates for very low…

The ALICE collaboration is proposing a completely new detector, ALICE 3, for operation during the LHC Runs 5 and 6. One of the ALICE~3 subsystems is the Muon IDentifier detector (MID), which has to be optimised to be efficient for the…

A low-power prototype of neutron amplifier, based on a 70 MeV, high current proton cyclotron being installed at LNL for the SPES RIB facility, was recently proposed within INFN-E project. This prototype uses a thick Beryllium converter to…

A prototype module for an International Linear Collider (ILC) detector was built, installed, and tested between 2006 and 2009 at CERN and Fermilab as part of the CALICE test beam program, in order to study the possibilities of extending…

The International Linear Collider (ILC) is a proposed electron-positron collider with a center-of-mass energy of 500~GeV, and a peak luminosity of $2 \cdot 10^{34}~\mathrm{cm}^{-2}\mathrm{s}^{-1}$. The ILC will complement the Large Hadron…

A cylindrical GEM tracker is under construction in order to replace and improve the inner tracking system of the BESIII experiment. Tests with planar chamber prototypes were carried out on the H4 beam line of SPS (CERN) with muons of 150…

To maximize the physics potential of future neutrino oscillation experiments, it is proposed to build a 15-MW `proton driver' consisitng solely of a 3-GeV proton injector linac (PI) and a 17-GeV superconducting ILC-type linac (SCL). The…