Related papers: Algebraic Solution for Beamforming in Two-Way Rela…
The application of intelligent reflecting surface (IRS) depends on the knowledge of channel state information (CSI), and has been hindered by the heavy overhead of channel training, estimation, and feedback in fast-changing channels. This…
Relay selection enhances the performance of the cooperative networks by selecting the links with higher capacity. Meanwhile link adaptation improves the spectral efficiency of wireless data-centric networks through adapting the modulation…
In conventional secure precise wireless transmission (SPWT), fully digital beamforming (FDB) has a high secrecy performance in transmit antenna system, but results in a huge RF-chain circuit budget for medium-scale and large-scale systems.…
Perfect Space-Time Block Codes (PSTBCs) achieve full diversity, full rate, nonvanishing constant minimum determinant, uniform average transmitted energy per antenna, and good shaping. However, the high decoding complexity is a critical…
We address the problem of downlink beamformer design for signal-to-interference-plus-noise ratio (SINR) balancing in a multiuser multicell environment with imperfectly estimated channels at base stations (BSs). We first present a…
This paper considers transmit beamforming in dual-function radar-communication (DFRC) system, where a DFRC transmitter simultaneously communicates with a communication user and detects a malicious target with the same waveform. Since the…
The problem of maximum rate achievable with analog network coding for a unicast communication over a layered wireless relay network with directed links is considered. A relay node performing analog network coding scales and forwards the…
A decode and forward protocol based Trellis Coded Modulation (TCM) scheme for the half-duplex relay channel, in a Rayleigh fading environment, is presented. The proposed scheme can achieve any spectral efficiency greater than or equal to…
A non-regenerative dual-hop wireless system based on a distributed space-time coding strategy is considered. It is assumed that each relay retransmits an appropriately scaled space-time coded version of its received signal. The main goal of…
In this paper, a hybrid IRS-aided amplify-and-forward (AF) relay wireless network is put forward, where the hybrid IRS is made up of passive and active elements. For maximum signal-to-noise ratio (SNR), a low-complexity method based on…
Due to the double fading effect caused by conventional passive intelligent reflecting surface (IRS), the signal via the reflection link is weak. To enhance the received signal, active elements with the ability to amplify the reflected…
Massive multiple-input multiple-output (MIMO) avails of simple transceiver design which can tackle many drawbacks of relay systems in terms of complicated signal processing, latency, and noise amplification. However, the cost and circuit…
High-resolution fully digital transceivers are infeasible at millimeter-wave (mmWave) due to their increased power consumption, cost, and hardware complexity. The use of low-resolution converters is one possible solution to realize fully…
Most previous researches on bidirectional relay selection (RS) typically assume perfect channel state information (CSI). However, outdated CSI, caused by the the time-variation of channel, cannot be ignored in the practical system, and it…
This paper brings the novel idea of paying the utility to the winning agents in terms of some physical entity in cooperative communications. Our setting is a secret two-way communication channel where two transmitters exchange information…
Two-way relaying can improve spectral efficiency in two-user cooperative communications. It also has great potential in multiuser systems. A major problem of designing a multiuser two-way relay system (MU-TWRS) is transceiver or precoding…
We investigate the spectral efficiency of full-duplex small cell wireless systems, in which a full-duplex capable base station (BS) is designed to send/receive data to/from multiple halfduplex users on the same system resources. The major…
Multi-group multicast beamforming in wireless systems with large antenna arrays and massive audience is investigated in this paper. Multicast beamforming design is a well-known non-convex quadratically constrained quadratic programming…
In Part II of this two-part paper, a sum-rate-maximizing power allocation with minimum power consumption is found for multiple-input multiple-output (MIMO) decode-and-forward (DF) two-way relaying (TWR) in a network optimization scenario.…
Cell-free integrated sensing and communication (ISAC) systems are facing the resource allocation challenges due to the deployment of access points (APs) and conflicting beamforming requirements between the communication and sensing…