Related papers: Performance Analysis of Fifth-Generation Cellular …
The next generation of cellular networks (5G) will exploit the mmWave spectrum to increase the available capacity. Communication at such high frequencies, however, suffers from high path loss and blockage, therefore directional…
In this paper, the potential of extending 5G New Radio physical layer solutions to support communications in sub-THz frequencies is studied. More specifically, we introduce the status of third generation partnership project studies related…
Cell-Free (CF) Massive MIMO (mMIMO) is a technology which can potentially augment not only the deployment of 5G, but also the deployment of beyond 5G (B5G) wireless networks. However, the cost for rolling out such systems may be…
A typical handover problem requires sequence of complex signaling between a UE, the serving, and target base station. In many handover problems the down link based measurements are transferred from a user equipment to a serving base station…
The concept of user-centric and personalized service in the fifth generation (5G) mobile networks encourages technical solutions such as dynamic asymmetric uplink/downlink resource allocation and elastic association of cells to users with…
Massive multiple-input multiple-output (MIMO) networks, where the base stations (BSs) are equipped with large number of antennas and serve a number of users simultaneously, are very promising, but suffer from pilot contamination. Despite…
Network densification and heterogenisation through the deployment of small cellular access points (picocells and femtocells) are seen as key mechanisms in handling the exponential increase in cellular data traffic. Modelling such networks…
We perform experiments on the wireless communication between a drone flying at different heights and a commercial 5G base station. An Android-based tool deployed on a 5G test platform is used to record radio link parameters in the up- and…
In this paper, an analytical framework is provided to analyze the uplink performance of device-to-device (D2D)-enabled millimeter wave (mmWave) cellular networks with clustered D2D user equipments (UEs). Locations of cellular UEs are…
Cell-free massive MIMO is a key 6G technology, offering superior spectral and energy efficiency. However, its dense deployment of low-cost access points (APs) makes hardware impairments unavoidable. While narrowband impairments are…
Decoupling uplink (UL) and downlink (DL) is a new architectural paradigm where DL and UL are not constrained to be associated to the same base station (BS). Building upon this paradigm, the goal of the present paper is to provide lower,…
A new analysis is presented for the direct-sequence code-division multiple access (DS-CDMA) cellular uplink. For a given network topology, closed-form expressions are found for the outage probability and rate of each uplink in the presence…
One of upcoming mobility enhancements in 5G-Advanced networks is to execute handover based on Layer 1 (L1) measurements using the so called lower layer mobility procedure. In this paper, we provide a system model for lower layer mobility…
In this paper, for the first time, we analytically prove that the uplink (UL) inter-cell interference in frequency division multiple access (FDMA) small cell networks (SCNs) can be well approximated by a lognormal distribution under a…
Multiple antenna technologies have attracted large research interest for several decades and have gradually made their way into mainstream communication systems. Two main benefits are adaptive beamforming gains and spatial multiplexing,…
Future cellular systems based on the use of above-6 GHz frequencies, the so-called millimeter wave (mmWave) bandwidths, will heavily rely on the use of antenna arrays both at the transmitter and at the receiver, possibly with a large number…
We study the problem of associating mobile terminals to base stations in a linear interference network, with the goal of maximizing the average rate achieved over both the uplink and downlink sessions. The cell association decision is made…
Energy-aware system design is an important optimization task for static and mobile Internet of Things (IoT)-based sensor nodes, especially for highly resource-constrained vehicles such as mobile robotic systems. For 4G/5G-based cellular…
CDMA is a multiple access method in which the user's uses spread spectrum techniques and occupy the entire spectrum whenever they transmit. In wireless communication signal-to-noise ratio (SNR) is the very important parameter that…
This paper analyzes how the distortion created by hardware impairments in a multiple-antenna base station affects the uplink spectral efficiency (SE), with focus on Massive MIMO. The distortion is correlated across the antennas, but has…