Related papers: Investigation of the Effect of Resistivity on Scra…
A complete model of the dynamics of scrape-off layer filaments will be rather complex, including temperature evolution, three dimensional geometry and finite Larmor radius effects. However, the basic mechanism of…
Theory-based scaling laws of the near and far scrape-off layer (SOL) widths are analytically derived for L-mode diverted tokamak discharges by using a two-fluid model. The near SOL pressure and density decay lengths are obtained by…
The properties of plasma turbulence in a poloidally limited scrape-off layer (SOL) are addressed, with focus on ISTTOK, a large aspect ratio tokamak with a circular cross section. Theoretical investigations based on the drift-reduced…
The SOL width is a parameter of paramount importance in modern tokamaks as it controls the power density deposited at the divertor plates, critical for plasma-facing material survivability. An understanding of the parameters controlling it…
A theoretical framework is developed to link the density profiles in the Scrape Off Layer (SOL) with the fluctuations (filaments) that generate them. The framework is based on the dynamics of independent filaments and their statistical…
Plasma-impurity reaction rates are a crucial part of modelling tokamak scrape-off layer (SOL) plasmas. To avoid calculating the full set of rates for the large number of important processes involved, a set of effective rates are typically…
The understanding of cross-field transport is crucial in order to optimize the properties of magnetic confinement in modern fusion devices. In this work, a two-dimensional, simplified model is used to study the turbulent dynamics in the…
A challenging and fundamental research problem is the better understanding and control of the turbulent transport of heat in present-day tokamak fusion experiments. Recent developments in numerical methods along with enormous gains in…
Non-linear simulations of filament propagation in a realistic MAST SOL flux tube geometry using the BOUT++ fluid modelling framework show an isolation of the dynamics of the filament in the divertor region from the midplane region due to…
The turbulence characteristics of the scrape-off-layer (SOL) plasma in the W7-X stellarator are investigated using a gas-puff-imaging (GPI) diagnostic, newly installed and operated during the OP 2.1 campaign. The SOL plasma on W7-X features…
Understanding turbulent transport physics in the tokamak edge and scrape-off layer (SOL) is critical to developing a successful fusion reactor. The dynamics in these regions plays a key role in achieving high fusion performance by…
There exists a large body of previous work using reduced two-dimensional models of the SOL, which model fluctuations in the drift-plane but approximate parallel transport with effective loss terms. Full size three-dimensional simulations of…
Enhancement of the scrape-off layer (SOL) heat flux width has been observed in the ADITYA-U Tokamak following the injection of short fuel gas pulses. A notable reduction in parallel heat flux near the last closed flux surface (LCFS) is…
Beams of energetic runaway electrons are generated during disruptions in tokamaks, and fluid models are used to study their effects on macroscale dynamics. Linear computations of a massless, runaway electron beam coupled to MHD plasma show…
Low-recycling regimes are appealing because they entail a high edge temperature and low edge density which are good for core confinement. However, due to considerably enhanced heat flux, the exhaust problems become severe. In addition, in…
A control oriented, lumped parameter model for the tokamak transformer including the slow flux penetration in the plasma (skin effect transformer model) is presented. The model does not require detailed or explicit information about plasma…
A summary of recent results on filamentary transport, mostly obtained in the ASDEX-Upgrade tokamak (AUG), is presented and discussed in an attempt to produce a coherent picture of SOL filamentary transport: A clear correlation is found…
We report the observation of a quasi-coherent density fluctuation (QCF) by the Doppler backscattering system in the scrape-off layer (SOL) region of the DIII-D tokamak. This QCF is observed in high-power, high-performance hybrid plasmas…
The understanding of the halo current properties during disruptions is key to design and operate large scale tokamaks in view of the large thermal and electromagnetic loads that they entail. For the first time, we present a fully…
A multidiagnostic approach, utilizing Langmuir probes in the midplane, X-point and divertor walls, along with Lithium beam and infrared measurements is employed to evaluate the evolution of the Scrape-off Layer (SOL) of ASDEX Upgrade across…