Related papers: Temperature Measurement and Phonon Number Statisti…
We present a superconducting microresonator thermometer based on two-level systems (TLS) that is drop-in compatible with cryogenic microwave systems. The operational temperature range is 50-1000~mK (which may be extended to 5~mK), and the…
A thermocouple of Au-Ni with only 2.5-micrometers-wide electrodes on a 30-nm-thick Si3N4 membrane was fabricated by a simple low-resolution electron beam lithography and lift off procedure. The thermocouple is shown to be sensitive to heat…
We study theoretically dynamics of a driven-dissipative qubit-resonator system. Specifically, a transmon qubit is coupled to a transmission-line resonator; this system is considered to be probed via a resonator, by means of either…
A sensor for thermal and thermodynamic measurements of small magnetic systems have been designed and built. It is based on a 5μm-thick suspended polymer membrane, which has a very low heat capacity (≈ 10-6 J/K at nitrogen…
We demonstrate a new method to directly manipulate the state of individual two-level systems (TLS) in phase qubits. It allows one to characterize the coherence properties of TLS using standard microwave pulse sequences, while the qubit is…
A differential, membrane-based nanocalorimeter for general specific heat studies of very small samples, ranging from 0.5 mg to sub-{\mu}g in mass, is described. The calorimeter operates over the temperature range from above room temperature…
Temperature is a fundamental parameter in the study of physical phenomena. At the nanoscale, local temperature differences can be harnessed to design novel thermal nanoelectronic devices or test quantum thermodynamical concepts. Determining…
We report local time-resolved thermometry in a silicon nanowire quantum dot device designed to host a linear array of spin qubits. Using two alternative measurement schemes based on rf reflectometry, we are able to probe either local…
Here we find the increase in 1/f noise of superconducting resonators at low temperatures to be completely incompatible with the standard tunneling model (STM) of Two Level Systems (TLS), which has been used to describe low-frequency noise…
Resistance thermometry provides a time-tested method for taking temperature measurements. However, fundamental limits to resistance-based approaches has produced considerable interest in developing photonic temperature sensors to leverage…
The position noise spectra of six drums on a single chip were measured on a single cooldown below 1.3 kelvin. Cryostat temperatures as low as 0.7 mK were achieved. The temperature dependence of the resonance frequency and linewidth of the…
In nanomechanical photothermal absorption spectroscopy and microscopy, the measured substance becomes a part of the detection system itself, inducing a nanomechanical resonance frequency shift upon thermal relaxation. Suspended,…
Studying thermal transport at the nanoscale poses formidable experimental challenges due both to the physics of the measurement process and to the issues of accuracy and reproducibility. The laser-induced transient thermal grating (TTG)…
Nanomechanical resonators have demonstrated great potential for use as versatile tools in a number of emerging quantum technologies. For such applications, the performance of these systems is restricted by the decoherence of their fragile…
The method consists in the monitoring of the temperature variation of a superconductor tape subjected to a trapezoidal current pulse. Simulations of the experiment were performed using the lumped capacitance model and also the finite…
Superconducting circuits provide a versatile and controllable platform for studies of fundamental quantum phenomena as well as for quantum technology applications. A conventional technique to read out the state of a quantum circuit or to…
Nanomechanical resonators promise diverse applications ranging from mass spectrometry to quantum information processing, requiring long phonon lifetimes and frequency stability. Although two-level system (TLS) defects govern dissipation at…
We present a novel high resolution contactless technique for thermal conductivity determination and thermal field mapping based on creating a thermal distribution of phonons using a heating laser, while a second laser probes the local…
Quantifying the temperature of microdevices is critical for probing nanoscale energy transport.Such quantification is often accomplished by integrating resistance thermometers into microdevices. However, such thermometers frequently become…
Understanding heat transport is relevant to develop efficient strategies for thermal management in microelectronics for instance, as well as for fundamental science purposes. However, measuring temperatures in nanostructured environments…