Related papers: A Mixed-ADC Receiver Architecture for Massive MIMO…
In this paper we present low-complexity blind multi-input multi-output (MIMO) adaptive linear multiuser receivers for direct sequence code division multiple access (DS-CDMA) systems using multiple transmit antennas and space-time block…
Even if massive multiple-input multiple-output (MIMO) can theoretically bring huge benefits, it incurs substantial hardware complexity and expensive hardware costs. To address these issues while maintaining the system performance…
A one-bit wireless transceiver is a promising communication architecture that not only can facilitate the design of mmWave communication systems but also can extremely diminish power consumption. The non-linear distortion effects by one-bit…
In millimeter wave (mmWave) systems, we investigate uplink user scheduling when a basestation employs low-resolution analog-to-digital converters (ADCs) with a large number of antennas. To reduce power consumption in the receiver,…
Millimeter-wave (mmWave) technology is one of the most promising candidates for future wireless communication systems as it can offer large underutilized bandwidths and eases the implementation of large antenna arrays which are required to…
In this paper, we investigate the design of linear precoders for multiple-input multiple-output (MIMO) multiple access channels (MAC). We assume that statistical channel state information (CSI) is available at the transmitters and consider…
Massive MIMO is a variant of multiuser MIMO where the number of base-station antennas $M$ is very large (typically 100), and generally much larger than the number of spatially multiplexed data streams (typically 10). Unfortunately, the…
In frequency division duplexing (FDD) mode, it is necessary to send the channel state information (CSI) from user equipment to base station. The downlink CSI is essential for the massive multiple-input multiple-output (MIMO) system to…
Information transmission over a multiple-input-multiple-output (MIMO) fading channel with imperfect channel state information (CSI) is investigated, under a new receiver architecture which combines the recently proposed generalized nearest…
Massive multiple-input multiple-output (MIMO) systems are cellular networks where the base stations (BSs) are equipped with unconventionally many antennas. Such large antenna arrays offer huge spatial degrees-of-freedom for transmission…
We study the massive multiple-input multiple-output (MIMO) multicast transmission in cellular networks where each base station (BS) is equipped with a large-scale antenna array and transmits a common message using a single beamformer to…
This paper considers a multipair amplify-and-forward massive MIMO relaying system with low-resolution ADCs at both the relay and destinations. The channel state information (CSI) at the relay is obtained via pilot training, which is then…
Hybrid multiple-antenna transceivers, which combine large-dimensional analog pre/postprocessing with lower-dimensional digital processing, are the most promising approach for reducing the hardware cost and training overhead in massive MIMO…
The use of low-resolution Analog-to-Digital Converters (ADCs) is a practical solution for reducing cost and power consumption for massive Multiple-Input-Multiple-Output (MIMO) systems. However, the severe nonlinearity of low-resolution ADCs…
This paper considers a downlink cell-free multiple-input multiple-output (MIMO) network in which multiple multi-antenna access points (APs) serve multiple users via coherent joint transmission. In order to reduce the energy consumption by…
A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…
To meet the future demand for huge traffic volume of wireless data service, the research on the fifth generation (5G) mobile communication systems has been undertaken in recent years. It is expected that the spectral and energy efficiencies…
In Massive MIMO base stations (BSs), the hardware design needs to balance high spectral efficiency (SE) with low complexity. The level of hardware impairments (HWIs) indicates how strong the signal distortion introduced by hardware…
In a growing number of applications, there is a need to digitize a (possibly high) number of correlated signals whose spectral characteristics are challenging for traditional analog-to-digital converters (ADCs). Examples, among others,…
In this letter, we propose a six-dimensional movable antenna (6DMA)-aided cell-free massive multiple-input multiple-output (MIMO) system to fully exploit its macro spatial diversity, where a set of distributed access points (APs), each…