Related papers: Weak measurement amplification based on thermal no…
Temperature fluctuations are expected to be one of the limiting factors for gravitational wave detectors in the very low frequency range. Here we report the characterisation of this noise source in the LISA Pathfinder optical bench and…
We study the photon statistics of a single-mode sub-Poissonian light propagating in the temperature-loss bosonic channel with fluctuating transmittance which can be regarded as a temperature-dependent model of turbulent atmosphere. By…
We provide a full quantum mechanical analysis of a weak energy measurement of a driven mechanical resonator. We demonstrate that measurements too weak to resolve individual mechanical Fock states can nonetheless be used to unambiguously…
Quantum optical measurement techniques offer a rich avenue for quantum control of mechanical oscillators via cavity optomechanics. In particular, a powerful yet little explored combination utilizes optical measurements to perform heralded…
Weak values and measurements have been proposed as means to achieve dramatic enhancements in metrology based on the greatly increased range of possible measurement outcomes. Unfortunately, the very large values of measurement outcomes occur…
We have performed a quantum mechanical analysis of travelling-wave parametric amplifiers (TWPAs) in order to investigate five experimental phenomena related to their operations, namely the effect of impedance mismatch, the presence of upper…
We propose granularity noise thermometry (GNT), a fluctuation-based optical thermometry scheme that exploits the intrinsic fluctuations of susceptibility arising from atomic discreteness. The power spectral density of transmitted light…
Intracavity squeezing is a promising technique that may improve the sensitivity of gravitational wave detectors and cool optomechanical oscillators to the ground state. However, the photothermal effect may modify the occurrence of…
It is usually expected and observed that non-integrable isolated quantum systems thermalize. However, for some non-integrable spin chain models, in a numerical study, initial states with oscillations that persisted for some time were found…
Reduction of coating thermal noise is a key issue in precise measurements with an optical interferometer. A good example of such a measurement device is a gravitational-wave detector, where each mirror is coated by a few tens of…
We study the photon counting noise in optical interferometers used for gravitational wave detection. In order to reduce quantum noise a squeezed vacuum state is injected into the usually unused input port. Here, we specifically investigate…
We report on the use of parametric excitation to coherently manipulate the collective spin state of an atomic vapour at room temperature. Signatures of the parametric excitation are detected in the ground-state spin evolution. These include…
Proposed near-future upgrades of the current advanced interferometric gravitational wave detectors include the usage of frequency dependent squeezed light to reduce the current sensitivity-limiting quantum noise. We quantify and describe…
Thermal noise of a mirror can be reduced by cold damping. The displacement is measured with a high-finesse cavity and controlled with the radiation pressure of a modulated light beam. We establish the general quantum limits of noise in cold…
High-gain and low-noise signal amplification is a valuable tool in various cryogenic microwave experiments. A microwave optomechanical device, in which a vibrating capacitor modulates the frequency of a microwave cavity, is one technique…
Vibrational resonance amplifies a weak low-frequency signal by use of an additional non-resonant high-frequency modulation. The realization of weak signal enhancement in integrated nonlinear optical nanocavities is of great interest for…
Weak measurement has been shown to play important roles in the investigation of both fundamental and practical problems. Anomalous weak values are generally believed to be observed only when post-selection is performed, i.e, only a…
Temperature influences the performance of two-dimensional materials in optoelectronic devices. Indeed, the optical characterization of these materials is usually realized at room temperature. Nevertheless most {\it ab-initio} studies are…
In this paper, we explore the possibilities of realizing weak value amplification (WVA) using purely atomic degrees of freedom. Our scheme identifies the internal electronic states and external motional states of a single trapped…
The temperature of the semiconductor diode increases under strong light illumination whether thermoelectric cooler is installed or not, which changes the output wavelength of the laser (Lee M. S. et al., 2017). However, other…