Related papers: Coexistence Analysis between Radar and Cellular Sy…
In practical cell-free (CF) massive multiple-input multiple-output (MIMO) networks with distributed and low-cost access points, the asynchronous arrival of signals at the user equipments increases multi-user interference that degrades the…
We analyze the uplink radio frequency (RF) interference from a multiplicity of single-antenna user equipments transmitting to a cellular base station (BS) within the same time-frequency resource. The BS is assumed to operate with a lens…
In this paper, we investigate an intelligent reflecting surface (IRS) assisted cell-free multiple input multiple output (MIMO) communication system, where distributed multiple IRSs are dedicated deployed to assist distributed multiple base…
As the number of user equipments increases in fifth generation (5G) and beyond, it is desired to densify the cellular network with auxiliary nodes assisting the base stations. Examples of these nodes are integrated access and backhaul (IAB)…
This paper studies the feasibility of deploying intelligent reflecting surfaces (IRSs) in massive MIMO (multiple-input multiple-output) systems to improve the performance of users in the service dead zone. To reduce the channel training…
This paper investigates the integration of a reconfigurable intelligent surface (RIS) into a secure multiuser massive multiple-input multiple-output (MIMO) system in the presence of transceiver hardware impairments (HWI), imperfect channel…
Automotive radars are increasingly susceptible to mutual interference from neighboring radar systems, which can lead to false target detections and the masking of valid targets. While current interference levels remain manageable due to the…
This paper investigates the reconfigurable intelligent surface (RIS) assisted spatial scattering modulation (SSM) scheme for millimeter-wave (mmWave) multiple-input multiple-output (MIMO) systems, in which line-of-sight (LoS) and…
In colocated multiple-input multiple-output (MIMO) radar using compressive sensing (CS), a receive node compresses its received signal via a linear transformation, referred to as measurement matrix. The samples are subsequently forwarded to…
Radar sensors are crucial for environment perception of driver assistance systems as well as autonomous cars. Key performance factors are a fine range resolution and the possibility to directly measure velocity. With a rising number of…
By employing the lens antenna array, beamspace MIMO can utilize beam selection to reduce the number of required RF chains in mmWave massive MIMO systems without obvious performance loss. However, to achieve the capacityapproaching…
Massive Multiple Input-Multiple Output (mMIMO) technique has been considered an efficient standard to improve the transmission rate significantly for the following wireless communication systems, such as 5G and beyond. However, implementing…
In automotive systems, a radar is a key component of autonomous driving. Using transmit and reflected radar signal by a target, we can capture the target range and velocity. However, when interference signals exist, noise floor increases…
The application of intelligent reflecting surface (IRS) depends on the knowledge of channel state information (CSI), and has been hindered by the heavy overhead of channel training, estimation, and feedback in fast-changing channels. This…
To enable densely deployed base stations (BSs) or access points (APs) to serve an increasing number of users and provide diverse mobile services, we need to improve spectrum utilization in wireless communication networks. Although spectral…
Multiple-input multiple-output (MIMO) radar systems have been shown to achieve superior resolution as compared to traditional radar systems with the same number of transmit and receive antennas. This paper considers a distributed MIMO radar…
We characterize the rate coverage distribution for a spectrum-shared millimeter wave downlink cellular network. Each of multiple cellular operators owns separate mmWave bandwidth, but shares the spectrum amongst each other while using…
Due to ever increasing usage of wireless devices and data hungry applications, it has become necessary to improve the spectral efficiency of existing wireless networks. One way of improving spectral efficiency is to share the spectrum…
Wireless communications via intelligent reflecting surfaces (IRSs) has received considerable attention from both academia and industry. In particular, IRSs are able to create favorable wireless propagation environments with typically…
Cell-Free Massive multiple-input multiple-output (MIMO) and reconfigurable intelligent surface (RIS) are two promising technologies for application to beyond-5G networks. This paper considers Cell-Free Massive MIMO systems with the…