Related papers: Pulling and Stretching a Molecular Wire to Tune it…
We measure electronic conductance through single conjugated molecules bonded to Au metal electrodes with direct Au-C covalent bonds using the scanning tunneling microscope based break-junction technique. We start with molecules terminated…
A scanning tunneling microscope (STM) has been equipped with a nanoscale force sensor and signal transducer composed of a single D2 molecule that is confined in the STM junction. The uncalibrated sensor is used to obtain ultra-high…
We discuss the emergence of a spontaneous temperature and critical current spatial modulation in current-carrying high temperature superconducting wire. The modulation of the critical current along the wire on a scale of 3 - 10 mm forces a…
The linear conductance of a molecular conductor oscillating between two metallic leads is investigated numerically both for Hubbard interacting and noninteracting electrons. The molecule-leads tunneling barriers depend on the molecule…
The wire scanners are used for a measurement of the very small beam size and the emittance in Accelerator Test Facility (ATF). They are installed in the extraction beam line of ATF damping ring. The extracted beam emittance are ex=1.3x10-9…
This paper gives a method that maps the static magnetic field due to a system of parallel current-carrying wires to a complex function. Using this function simplifies the calculation of the magnetic field energy density and inductance per…
After an initial transient period, the conduction regime in a 1D superconducting wire that carries a fixed current is either normal or periodic or stationary. The phase diagram for these possibilities was studied in Phys. Rev. Lett. {\bf…
An arrangement of mesoscopic experiments is considered when the conductance of a mesoscopic normal metal sample is governed not only by the magnetic flux threading the sample but by the supercurrent inside the superconductor coupled to the…
The qPlus sensor allows simultaneous measurements of scanning tunneling microscopy (STM) and atomic force microscopy (AFM). Its design for use in frequency modulation AFM (FM-AFM) involves separate electrodes, applied on an oscillating…
The first electrical conductivity measurements of monoatomic carbon chains are reported in this study. The chains were obtained by unraveling carbon atoms from graphene ribbons while an electrical current flowed through the ribbon and,…
Nonlinear effects are omnipresent in thin films of ion conducting materials showing up as a significant increase of the conductivity. For a disordered hopping model general physical mechanisms are identified giving rise to the occurrence of…
The dynamics of a molecular junction consisting of a PTCDA molecule between the tip of a scanning tunneling microscope and a Ag(111) surface have been investigated experimentally and theoretically. Repeated switching of a PTCDA molecule…
A conducting bridge of a single hydrogen molecule between Pt electrodes is formed in a break junction experiment. It has a conductance near the quantum unit, G_0 = 2e^2/h, carried by a single channel. Using point contact spectroscopy three…
Spin-density-functional calculations of tip-suspended gold chains, with molecular oxygen, or dissociated oxygen atoms, incorporated in them, reveal structural transitions for varying lengths. The nanowires exhibit enhanced strength for both…
Explicit predictions for Scanning Tunneling Microscopy (STM) on interacting one-dimensional electron systems are made using the Luttinger liquid formalism. The STM current changes with distance from an impurity or boundary in a…
The reliable operation of micro and nanomechanical devices necessitates a thorough knowledge of the water film thickness present on the surfaces of these devices with an accuracy in the nm range. In this work, the thickness of an ultra-thin…
Recent years have shown steady progress in research towards molecular electronics [1,2], where molecules have been investigated as switches [3-5], diodes [6], and electronic mixers [7]. In much of the previous work a Scanning Tunnelling…
A way to increase the Scanning Thermal Microscope (SThM) sensitivity in the harmonic 3w mode is to heat the probe with an AC current sufficiently high to generate a coupling between the AC and the DC signals. We detail in this paper how to…
We study photon assisted tunneling in Nb/AlOx/Nb Josephson junctions. A quantitative calibration of the microwave field in the junction allowed direct verification of the quantum efficiency of microwave photon detection by the junctions. We…
Coherent spin-dependent electronic transport is investigated in a molecular junction made of polymeric chain attached to ferromagnetic electrodes (Ni and Co, respectively). Molecular system is described by a simple Huckel model, while the…