Related papers: Interference-Nulling Time-Reversal Beamforming for…
Modern millimeter wave (mmWave) communication systems rely on beam alignment to deliver sufficient beamforming gain to close the link between devices. We present a novel beam selection methodology for multi-panel, full-duplex mmWave…
This paper studies the feasibility of deploying intelligent reflecting surfaces (IRSs) in massive MIMO (multiple-input multiple-output) systems to improve the performance of users in the service dead zone. To reduce the channel training…
Integrated sensing and communication (ISAC) unifies sensing and communication, and improves the efficiency of the spectrum, energy, and hardware. In this work, we investigate the ISAC beamforming design to maximize the mutual information…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
This paper compares two important downlink multicell interference mitigation techniques, namely, large-scale (LS) multiple-input multiple-output (MIMO) and network MIMO. We consider a cooperative wireless cellular system operating in…
In this paper, the problem of outer beamformer design based only on channel statistic information is considered for two-stage beamforming for multi-user massive MIMO downlink, and the problem is approached based on…
We consider the problem of coordinated multi- cell downlink beamforming in massive multiple input multiple output (MIMO) systems consisting of N cells, Nt antennas per base station (BS) and K user terminals (UTs) per cell. Specifically, we…
Deploying massive number of antennas at the base station side can boost the cellular system performance dramatically. Meanwhile, it however involves significant additional radio-frequency (RF) front-end complexity, hardware cost and power…
Recently, terahertz (THz) communication has drawn considerable attention as one of the promising technologies for the future wireless communications owning to its ultra-wide bandwidth. Nonetheless, one major obstacle that prevents the…
In this paper, we focus on reduced complexity full duplex Multiple-Input Multiple-Output (MIMO) systems and present a joint design of digital transmit and receive beamforming with Analog and Digital (A/D) self-interference cancellation. We…
Non-orthogonal multiple access (NOMA) and millimeter wave (mmWave) are two key enabling technologies for the fifth-generation (5G) mobile networks and beyond. In this paper, we consider mmWave NOMA systems with max-min fairness constraints.…
Data rate requirements for cellular communications are expected to increase 1000-fold by 2020, compared to 2010. This is mainly because of the rapid increase in the number of wireless devices and data hungry applications per-device. This…
The combination of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems and index modulation (IM) technique has recently constituted a novel form of mmWave hybrid beamforming. Lots of studies have been conducted to show…
Despite its promising performance gain, the realization of mmWave massive MIMO still faces several practical challenges. In particular, implementing massive MIMO in the digital domain requires hundreds of RF chains matching the number of…
In a cell-free wireless network, distributed access points (APs) jointly serve all user equipments (UEs) within the their coverage area by using the same time/frequency resources. In this paper, we develop a novel downlink cell-free…
For millimeter-wave (mmWave) massive MIMO systems, the codebook-based analog beamforming (including transmit precoding and receive combining) is usually used to compensate the severe attenuation of mmWave signals. However, conventional…
Beamspace dimensionality reduction, a classical tool in array processing, has been shown in recent work to significantly reduce computational complexity and training overhead for adaptive reception in massive multiuser (MU) MIMO. For sparse…
Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…
The use of the millimeter (mm) wave spectrum for next generation (5G) mobile communication has gained significant attention recently. The small carrier wavelengths at mmwave frequencies enable synthesis of compact antenna arrays, providing…
In this paper, we study the problem of joint active and passive beamforming for intelligent reflecting surface (IRS)-assisted massive MIMO systems, where multiple IRSs equipped with a large number of passive elements are deployed to assist…