Related papers: RF modulation studies on the S band pulse compress…
This paper presents the index modulation, that is, the space-shift keying (SSK) and reflection phase modulation (RPM) schemes for intelligent reflecting surface (IRS)-assisted wireless network. IRS simultaneously reflects the incoming…
Four kinds of waveguide power dividers with different structures working at 2.856 GHz are developed. By comparing the simulation performances of these four structures, the power divider with matching rod in the middle of its structure has…
Intelligent reflecting surfaces (IRSs) have attracted considerable attention because of their ability to dynamically control electromagnetic wave propagation. While most existing IRSs have been developed for low-power communication and…
Magnetrons are widely used as a high-efficiency, large-power, and low-cost microwave source. This article proposes a method to improve the magnetron output characteristics based on regulating its anode current by a novel active distortion…
Achieving the highest possible mass resolving power in a multi-reflection time-of-flight mass spectrometer requires very high-stability power supplies. To this end, we have developed a programmable high-voltage power supply that can achieve…
A picosecond pulse generator based on a pair of step recovery diodes (SRD), leveraging the transient response of the SRD PN junction and controlling the pulse width by a resistor, is proposed. We first explain the operation principle of the…
Long pulse modulators are used to produce high-voltage, high-power pulses with durations of several hundred microseconds up to some milliseconds. The loads are one or more klystrons for producing RF power to accelerate the particle beam in…
We analyse the limitation of the amplitude modulation rejection due to the spatial modulation of the output beam of an acousto-optic modulator used in an active laser beam stabilisation system when a frequency modulation of a few megahertz…
The spectrum of a CW field whose phase experiences a periodic sawtooth modulation is analyzed. Two types of the sawtooth phase modulation are considered. One is created by combining many harmonics of the fundamental frequency. The second is…
The high power test model of biperiodic L-support disk-and- washer was fabricated. Among some trouble in the fabrication, the main one was a vacuum leak in a brazing process. The repair test of the leak showed a good result; four units were…
This paper presents the design and implementation of a simple, single-layer, broadband (97%, 11.3-32.3 GHz) Radar Cross Section Reduction (RCSR) Modulated Surface (MS). It uses modulation of the edge-length of the square patch (SP)…
This paper presents the experimental demonstration of a dual-input/dual-output reflective impedance metasurface. The design of the metasurface relies on the Method of Moments and leverages auxiliary surface waves to achieve anomalous…
Tsinghua University has designed an X-band (11.424 GHz) slow-wave parallel-coupling accelerating structure, and demonstrated the high performance of the over-coupled structure operating with ultrashort pulse. In this study, we redesigned a…
This work presents a switchable frequency-selective rasorber (SFSR) with two operating modes. Switching from transmission to reflection can be achieved by appropriately adding feeders and PIN diodes based on cascaded two-dimensional lossy…
The present study revisits the amplitude modulation phenomenon, specifically for the robustness in its quantification. To achieve this, a well-resolved large-eddy simulation (LES) data set at Re_theta= 8200 is used. First, the fluctuating…
In this article, we derive analytically the complex optical spectrum of a pulsed laser source obtained when a frequency comb generated by phase modulation is input into a synchronized intensity modulator. We then show how this knowledge of…
This paper presents an efficient dual-band rectifier for radiofrequency energy harvesting (RFEH) applications at FM and GSM bands. The single-port rectifier circuit, which comprises a 3-port network, optimized T-matching circuits and…
A beam line is built after the IHEP RFQ for halo study. To determine transverse emittance and ellipse parameters of the RFQ output beam, beam size data obtained from the first two of 14 wire scanners are employed. By using the transfer…
We design, test, and analyze fiber-optic voltage sensors based on optical reflection from a piezoelectric transducer. By controlling the physical dimensions of the device, we can tune the frequency of its natural resonance to achieve a…
We report on the response characteristics of plasmonic terahertz field-effect transistors (TeraFETs) fed with femtosecond and picosecond pulses. Varying the pulse width (tpw) from 10-15 s to 10-10 s under a constant input power condition…