Related papers: Amplitude response of a Fabry-Perot interferometer
We explore the use of Fabry-P\'erot cavities as high-pass filters for squeezed light, and show that they can increase the sensitivity of interferometric gravitational-wave detectors without the need for long (kilometer scale) filter…
The electron transmission through a {\it closed} Aharonov-Bohm mesoscopic solid-state interferometer, with a quantum dot (QD) on one of the paths, is calculated exactly for a simple model. Although the conductance is an even function of the…
The dynamics of Fabry-Perot cavity with suspended mirrors is described. The suspended mirrors are nonlinear oscillators interacting with each other through the laser circulating in the cavity. The degrees of freedom decouple in normal…
It is shown that an aberrated wavefront incident upon a Fabry-Perot optical cavity excites higher order spatial modes in the cavity, and that the spectral width and distribution of these modes is indicative of the type and magnitude of the…
Direct observations of gravitational waves at frequencies below 10 Hz will play crucial roles for fully exploiting the potential of gravitational wave astronomy. One approach to pursue this direction is the utilization of laser…
A spherical Fabry-Perot interferometer with adjustable mirror spacing is used to produce interference fringes with frequency separation (c/2L)/N, N=2-15. The conditions for observation of these fringes are derived from the consideration of…
A new type of an optical interferometer is discussed the phase difference between the interfering beams in which is substantially wavelength dependent. It is shown that the function measured with this device is an integral transform of the…
The 'optical spring' results from dynamical back-action and can be used to improve the sensitivity of cavity-enhanced gravitational-wave detectors. The effect occurs if an oscillation of the cavity length results in an oscillation of the…
Optomechanical arrays made of structured flexible dielectrics are a promising system for exploring quantum and many-body optomechanical phenomena. We generalize investigations of the optomechanical properties of periodic arrays of…
We present the first demonstration of real-time closed-loop control and deterministic tuning of an independently suspended Fabry-Perot optical cavity using digitally-enhanced heterodyne interferometry, realising a peak sensitivity of…
We theoretically and experimentally demonstrate coherence phenomena in optical parametric amplification inside a cavity. The mode splitting in transmission spectra of phase-sensitive optical parametric amplifier is observed. Especially, we…
Displacement calibration of nanomechanical plate resonators presents a challenging task. Large nanomechanical resonator thickness reduces the amplitude of the resonator motion due to its increased spring constant and mass, and its unique…
Here we introduce interferometric devices by combining optical feedback (cavities) with unbiased multiports, which unlike traditional beam dividers, allow light to reflect back out of the port from which it originated. By replacing the…
Speckle metrology is a powerful tool in the measurement of wavelength and spectra. Recently, speckle produced by multiple reflections inside an integrating sphere has been proposed and showed high performance. However, to our knowledge, a…
Length and g-factor are fundamental parameters that characterize optical cavities. We developed a technique to measure these parameters in-situ by determining the frequency spacing between the resonances of fundamental and spatial modes of…
Optical fiber Fabry-Perot cavities have been a development facilitating the efficient integration of high-finesse cavities into fiber-optic assemblies. In this work, we demonstrate coupling of two high-finesse fiber cavities by direct…
Concatenated modal interferometers based multipoint sensing system for detection of instantaneous amplitude, frequency, and phase of mechanical vibrations is proposed and demonstrated. The sensor probes are fabricated using identical…
We investigated the opto-mechanical properties of a Fabry-Perot cavity with a mirror mounted on a spring. Such a structure allows the cavity length to change elastically under the effect of light induced forces. This opto-mechanical…
Reflectometry is a technique that uses the light reflected by a sample to determine properties of the sample. Interferometric reflectometry uses interference between two beams, one of which is incident on ---and reflected back by--- a…
We describe a technique for measuring the complex reflectivity of an optical cavity with a resonant local oscillator laser and an auxiliary probe laser, each coupled via opposite ends of the cavity. A heterodyne sensing scheme is then used…