Related papers: Planck 2015 results. II. Low Frequency Instrument …
The Planck Low Frequency Instrument (LFI) radiometers have been tested extensively during several dedicated campaigns. The present paper reports the principal noise properties of the LFI radiometers.
This paper is part of the Prelaunch status LFI papers published on JINST (http://www.iop.org/EJ/journal/-page=extra.proc5/1748-0221). Planck's Low Frequency Instrument is an array of 22 pseudo-correlation radiometers at 30, 44, and 70 GHz.…
We present a reproduction of the Planck 2018 angular power spectra at $\ell > 30$, and associated covariance matrices, for intensity and polarization maps at 100, 143 and 217 GHz. This uses a new, publicly available, pipeline that is part…
This paper is part of the Prelaunch status LFI papers published on JINST: http://www.iop.org/EJ/journal/-page=extra.proc5/jinst . This paper describes the impact of the Planck Low Frequency Instrument front end physical temperature…
This paper presents the Planck 2015 likelihoods, statistical descriptions of the 2-point correlations of CMB data, using the hybrid approach employed previously: pixel-based at $\ell<30$ and a Gaussian approximation to the distribution of…
The Low Frequency Instrument (LFI) of the "Planck Surveyor" ESA mission will perform high-resolution imaging of the Cosmic Microwave Background anisotropies at four frequencies in the 30-100 GHz range. We review the LFI main scientific…
We describe the detection, interpretation, and removal of the signal resulting from interactions of high energy particles with the \Planck\ High Frequency Instrument (HFI). There are two types of interactions: heating of the 0.1\,K…
Aims. To investigate the performance of a deconvolution map-making algorithm for an experiment with a circular scanning strategy, specifically in this case for the analysis of Planck data, and to quantify the effects of making maps using…
This paper is one of a series describing the performance and accuracy of map-making codes as assessed by the Planck CTP working group. We compare the performance of multiple codes written by different groups for making polarized maps from…
We study the impact of the 1/f noise on the PLANCK Low Frequency Instrument (LFI) osbervations (Mandolesi et al 1998) and describe a simple method for removing striping effects from the maps for a number of different scanning stategies. A…
We present foreground-reduced CMB maps derived from the full Planck data set in both temperature and polarization. Compared to the corresponding Planck 2013 temperature sky maps, the total data volume is larger by a factor of 3.2 for…
Since October 1, 2006, spectroscopic data from the two FORS instruments have been reduced with a new pipeline, which is based on a bottom-up calibration approach. I give a short description of the pipeline and discuss first experiences with…
This paper describes the 2018 Planck CMB likelihoods, following a hybrid approach similar to the 2015 one, with different approximations at low and high multipoles, and implementing several methodological and analysis refinements. With more…
We present a Bayesian method for estimating instrumental noise parameters and propagating noise uncertainties within the global BeyondPlanck Gibbs sampling framework, and apply this to Planck Low Frequency Instrument (LFI) time-ordered…
this paper is part of the Prelaunch status LFI papers published on JINST: http://www.iop.org/EJ/journal/-page=extra.proc5/jinst The Low Frequency Instrument is optically interfaced with the ESA Planck telescope through 11 corrugated feed…
The data produced by the future space-based millihertz gravitational-wave detector LISA will require nontrivial pre-processing, which might affect the science results. It is crucial to demonstrate the feasibility of such processing…
We discuss the methods employed to photometrically calibrate the data acquired by the Low Frequency Instrument on Planck. Our calibration is based on a combination of the Orbital Dipole plus the Solar Dipole, caused respectively by the…
The Radiometer Electronics Box Assembly (REBA) is the control and data processing on board computer of the Low Frequency Instrument (LFI) of the Planck mission (ESA). The REBA was designed and built incorporating state of the art…
The Planck On-Fligh Forecaster (POFF) is a tool to predict when a position in the sky will be within a selected angular distance from any receiver direction of the Planck satellite according to its pre-programmed observational strategy.…
With the arrival of a number of wide-field snapshot image-plane radio transient surveys, there will be a huge influx of images in the coming years making it impossible to manually analyse the datasets. Automated pipelines to process the…