Related papers: Dissipative scale effects in strain-gradient plast…
We use a continuous mesoscopic model to address the yielding properties of plastic composites, formed by a host material and inclusions with different elastic and/or plastic properties. We investigate the flow properties of the composed…
Cessation of flow in simple yield stress fluids results in a complex stress relaxation process that depends on the preceding flow conditions and leads to finite residual stresses. To assess the microscopic origin of this phenomenon, we…
Based on the atomistic studies presented in Part I we develop analytical yield criteria for single crystals that capture the effect of shear stresses other than the Schmid stress (non-glide stresses) on the shear stress needed for…
The subject of this work is the instability mechanism of simple shear flows, like Hagen-Poiseuille pipe flow, which is a long-standing problem in fluid mechanics [1,2]. A possible analogy with phenomenological theory of ideal plasticity in…
We extend our earlier shear-transformation-zone (STZ) theory of amorphous plasticity to include the effects of thermally assisted molecular rearrangements. This version of our theory is a substantial revision and generalization of…
Size-dependence of plastic flow is studied by discrete dislocation dynamical simulation of systems with various numbers of interacting linear edge dislocations while the stress is slowly increased. Regions between avalanches in the…
A microfluidic approach to probing the first normal stress difference from single-point pressure measurements in transient shear flows is presented. Using an original experimental design, we examine the near-zero-mean pulsatile flow of…
We study the two-dimensional (2D) shear flow of amorphous solids within variants of an elastoplastic model, paying particular attention to spatial correlations and time fluctuations of, e.g., local stresses. The model is based on the local…
Micron-scale single crystalline materials deform plastically via large intermittent strain bursts that make the deformation process unpredictable. Here we investigate this stochastic phenomenon by analysing the plastic response of an…
We investigate the properties of self-diffusion in heterogeneous dense granular flows involving a gradient of stress and inertial number. The study is based on simulated plane shear with gravity and Poiseuille flows, in which non-local…
The spreading under surface tension and gravity of a droplet of yield-stress fluid over a thin film of the same material is studied. The droplet converges to a final equilibrium shape once the driving stresses inside the droplet fall below…
As an extension to strain-gradient models of size-dependent plastic behaviour, this work proposes a model for a stress-gradient theory. The model is distinguished from earlier works on the topic by its being embedded in a thermodynamically…
With the eventual aim of describing flowing elasto-plastic materials, we focus on the elementary brick of such a flow, a plastic event, and compute the long-range perturbation it elastically induces in a medium submitted to a global shear…
This study presents the spreading of a single filament of a yield stress (viscoplastic) fluid extruded onto a pre-wetted solid surface. The filaments spread laterally under surface tension forces until they reach a final equilibrium shape…
Suspensions are of wide interest and form the basis for many smart fluids. For most suspensions, the viscosity decreases with increasing shear rate, i.e. they shear thin. Few are reported to do the opposite, i.e. shear thicken, despite the…
We report on experimental measurements of the flow behavior of a wet, two-dimensional foam under conditions of slow, steady shear. The initial response of the foam is elastic. Above the yield strain, the foam begins to flow. The flow…
We study shear yielding and steady state flow of glassy materials with molecular dynamics simulations of two standard models: amorphous polymers and bidisperse Lennard-Jones glasses. For a fixed strain rate, the maximum shear yield stress…
Shear viscosity and wall slip of dense suspensions of a silicone polymer incorporated with polydisperse particles were investigated. Three types of particles with low aspect ratios were used to achieve a relatively high maximum packing…
Amorphous solids are yield stress materials that flow when a sufficient load is applied. Their flow consists of periods of elastic loading interrupted by rapid stress drops, or avalanches, coming from microscopic rearrangements known as…
Stability of coarse particles against gravity is an important issue in dense suspensions (fresh concrete, foodstuff, etc.). On the one hand, it is known that they are stable at rest when the interstitial paste has a high enough yield…