Related papers: Joint Channel-and-Data Estimation for Large-MIMO S…
This paper considers channel estimation and system performance for the uplink of a single-cell massive multiple-input multiple-output (MIMO) system. Each receive antenna of the base station (BS) is assumed to be equipped with a pair of…
The use of 1-bit analog-to-digital converters (ADCs) is seen as a promising approach to significantly reduce the power consumption and hardware cost of multiple-input multiple-output (MIMO) receivers. However, the nonlinear distortion due…
High power consumption and expensive hardware are two bottlenecks for practical massive multiple-input multiple-output (mMIMO) systems. One promising solution is to employ low-resolution analog-to-digital converters (ADCs) and…
This paper considers a multipair amplify-and-forward massive MIMO relaying system with one-bit ADCs and one-bit DACs at the relay. The channel state information is estimated via pilot training, and then utilized by the relay to perform…
In this paper, we study the channel estimation problem in correlated massive multiple-input-multiple-output (MIMO) systems with a reduced number of radio-frequency (RF) chains. Importantly, other than the knowledge of channel correlation…
The fundamental limits of communication over multiple-input multiple-output (MIMO) networks are considered when a limited number of one-bit analog to digital converters (ADC) are used at the receiver terminals. Prior works have mainly…
This paper considers uplink massive multiple-input multiple-output (MIMO) systems with lowresolution analog-to-digital converters (ADCs) over Rician fading channels. Maximum-ratio-combining (MRC) and zero-forcing (ZF) receivers are…
We study the spectral efficiency (SE) of a mixed-ADC massive MIMO system in which K single-antenna users communicate with a base station (BS) equipped with M antennas connected to N high-resolution ADCs and M-N one-bit ADCs. This…
This paper is concerned with channel estimation in MIMO systems with few-bit ADCs. In these systems, a linear minimum mean-squared error (MMSE) channel estimator obtained in closed-form is not an optimal solution. We first consider a deep…
The estimation of millimeter wave (mmWave) massive multiple input multiple output (MIMO) channels becomes compelling when one-bit analog to digital converters (ADCs) are utilized. Furthermore, as the number of antenna increases, pilot…
A method for channel estimation in wideband massive Multiple-Input Multiple-Output (MIMO) systems using covariance identification is developed. The method is useful for Frequency-Division Duplex (FDD) at either sub-6GHz or millimeter wave…
In this letter, we investigate the downlink performance of massive multiple-input multiple-output (MIMO) systems where the base station is equipped with one-bit analogto-digital/digital-to-analog converters (ADC/DACs). Considering…
This paper considers training-based transmissions in massive multi-input multi-output (MIMO) systems with one-bit analog-to-digital converters (ADCs). We assume that each coherent transmission block consists of a pilot training stage and a…
In this paper, we investigate the capacity of massive multiple-input multiple-output (MIMO) systems corrupted by complex-valued additive white Gaussian noise (AWGN) when both the transmitter and the receiver employ 1-bit digital-to-analog…
Due to the power consumption and high circuit cost in antenna arrays, the practical application of massive multiple-input multiple-output (MIMO) in the sixth generation (6G) and future wireless networks is still challenging. Employing…
Analog to digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) receivers in large bandwidth millimeter-wave systems. Prior works have considered two mitigating solutions to…
The use of low-resolution analog-to-digital converters (ADCs) is considered to be an effective technique to reduce the power consumption and hardware complexity of wireless transceivers. However, in systems with low-resolution ADCs,…
This paper proposes a novel approach for designing channel estimation, beamforming and scheduling jointly for wideband massive multiple input multiple output (MIMO) systems. With the proposed approach, we first quantify the maximum number…
A potential tremendous spectrum resource makes millimeter wave (mmWave) communications a promising technology. High power consumption due to a large number of antennas and analog-to-digital converters (ADCs) for beamforming to overcome the…
Future wireless communications will rely on multiple-input multiple-output (MIMO) beamforming operating at millimeter wave (mmWave) frequency bands to deliver high data rates. To support flexible spatial processing and meet the demands of…