Related papers: Load-Modulated Single-RF MIMO Transmission for Spa…
Wireless power transfer (WPT) has garnered increasing attention due to its potential to eliminate device-side batteries. With the advent of (distributed) multiple-input multiple-output (MIMO), radio frequency (RF) WPT has become feasible…
Multiple-input multiple-output (MIMO) systems are required to communicate reliably at high spectral bands using a large number of antennas, while operating under strict power and cost constraints. In order to meet these constraints, future…
In massive MIMO systems, hybrid beamforming is an essential technique for exploiting the potential array gain without using a dedicated RF chain for each antenna. In this work, we consider the data phase in a massive MIMO communication…
Hybrid analog-digital architectures are considered as promising candidates for implementing millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems since they enable a considerable reduction of the required number of…
Sixth generation (6G) wireless networks are envisioned to include aspects of energy footprint reduction (sustainability), besides those of network capacity and connectivity, at the design stage. This paradigm change requires radically new…
Limited-backhaul cell-free Massive multiple-input multiple-output (MIMO), in which the fog radio access network (F-RAN) is implemented to exchange the information between access points (APs) and the central processing unit (CPU), is…
A low cost solution for constructing receiver signal points is investigated that combines a large number of constrained radio frequency (RF) frontends with a limited number of full RF chains. The constrained RF front ends have low cost and…
In this paper we consider the problem of full-duplex multiple-input multiple-output (MIMO) relaying between multi-antenna source and destination nodes. The principal difficulty in implementing such a system is that, due to the limited…
This paper presents the current state-of-the-art of massive antenna array architectures with significant front-end hardware savings, as an enabler for future small and powerful cell nodes that will be able to carry massive MIMO technology.…
The key obstacle to achieving the full potential of the millimeter wave (mmWave) band has been the poor propagation characteristics of wireless signals in this band. One approach to overcome this issue is to use antennas that can support…
In-band full-duplex (FD) operation is practically more suited for short-range communications such as WiFi and small-cell networks, due to its current practical limitations on the self-interference cancellation. In addition, cell-free…
This paper deals with the problem of jointly designing the source precoder, the relaying matrices, and the destination equalizer in a multiple-relay amplify-and-forward (AF) cooperative multiple-input multiple-output (MIMO) wireless…
This work proposes a novel joint design for multiuser multiple-input multiple-output wiretap channels. The base station exploits a switching network to connect a subset of its antennas to the available radio frequency chains. The switching…
In this paper, we consider the amplify-and-forward relay networks in mmWave systems and propose a hybrid precoder/combiner design approach. The phase-only RF precoding/combining matrices are first designed to support multi-stream…
In this paper, we present a non-coherent energy detection scheme for spatial modulation (SM) systems. In particular, the use of SM is motivated by its low-complexity implementation in comparison to multiple-input multiple-output (MIMO)…
In index modulation schemes, information bits are conveyed through indexing of transmission entities such as antennas, subcarriers, times slots, precoders, subarrays, and radio frequency (RF) mirrors. Index modulation schemes are attractive…
The increasing demand for wireless data transfer has been the driving force behind the widespread adoption of Massive MIMO (multiple-input multiple-output) technology in 5G. The next-generation MIMO technology is now being developed to…
In this paper, we have considered the optimization of the $M$-ary quadrature amplitude modulation (MQAM) constellation size to minimize the bit energy consumption under average bit error rate (BER) constraints. In the computation of the…
Reconfigurable distributed antenna and reflecting surface (RDARS) is a promising architecture for future sixth-generation (6G) wireless networks. In particular, the dynamic working mode configuration for the RDARS-aided system brings an…
Intelligent reflecting surface (IRS) is a promising technology to extend the wireless signal coverage and support the high performance communication. By intelligently adjusting the reflection coefficients of a large number of passive…