Related papers: Dealing in practice with hot-spots
In this review, we present and discussed the main trends in photovoltaics with emphasize on the conversion efficiency limits. The theoretical limits of various photovoltaics device concepts are presented and analyzed using a flexible…
This paper presents a range of methods to improve the accuracy of equation-based thermal models of PV modules at second-to-minute timescales. We present an RC-equivalent conceptual model for PV modules, where wind effects are captured. We…
The subject of this research is the development of an intelligent, integrated framework for the automated inspection of photovoltaic (PV) infrastructure that addresses the critical shortcomings of conventional methods, including thermal…
This paper proposes the implementation of a circuit based simulation for a Solar Photovoltaic (PV) cell in order to get the maximum power output. The model is established based on the mathematical model of the PV module. As the PV cell is…
Insufficient flexibility in system operation caused by traditional "heat-set" operating modes of combined heat and power (CHP) units in winter heating periods is a key issue that limits renewable energy consumption. In order to reduce the…
The electrical power network is gradually migrating from a centralized generation approach to a decentralized generation with high shares of renewable energy sources (RES). However, power systems with low shares of synchronous generation…
High solar Photovoltaic (PV) penetration on distribution systems can cause over-voltage problems. To this end, an Optimal Tap Control (OTC) method is proposed to regulate On-Load Tap Changers (OLTCs) by minimizing the maximum deviation of…
Thermophotovoltaic systems in principle enable utilization of heat that is usually regarded as wasted energy. However, the wavelength selectivity of the thermal emitter required for high efficiencies is rather difficult to control with…
We study the optimal management of a photovoltaic system's battery owned by a self-consumption group that aims to minimize energy consumption costs. We assume that the photovoltaic system is composed of a photovoltaic panel and a battery,…
The fault tolerance method currently used in High Performance Computing (HPC) is the rollback-recovery method by using checkpoints. This, like any other fault tolerance method, adds an additional energy consumption to that of the execution…
In modern power systems, the operating point, at which the demand and supply are balanced, may take different values due to changes in loads and renewable generation levels. Understanding the dynamics of stressed power systems with a range…
The photoelectric conversion efficiency of a solar cell is dependent on its temperature. When the solar radiation is incident on the photovoltaics (PV) panel, a large portion of it is absorbed by the underlying material which increases its…
Estimation of the generated power of renewable energy resources is in general important for planning operations as well as demand balance and power quality. This paper addresses the problem of the estimation of the short-term (3-hour ahead)…
Control over the amplitude, phase, and spatial distribution of visible-spectrum light underlies many technologies, but commercial solutions remain bulky, require high control power, and are often too slow. Active integrated photonics for…
Our work is motivated by environmental monitoring tasks, where finding the global maxima (i.e., hotspot) of a spatially varying field is crucial. We investigate the problem of identifying the hotspot for fields that can be sensed using an…
Utilizing solar energy to meet space heating and domestic hot water demand is very efficient (in terms of environmental footprint as well as cost), but in order to ensure that user demand is entirely covered throughout the year needs to be…
We consider a network of residential heating systems in which several prosumers satisfy their heating and hot water demand using solar thermal collectors and services of a central producer. Overproduction of heat can either be stored in a…
Environmental, economical and technical benefits of photovoltaic (PV) systems make them to be used in many countries. The main characteristic of PV systems is the fluctuations of their output power. Hence, high penetration of PV systems…
In this paper, the behavior of a photovoltaic (PV) system, with maximum power point tracking (MPPT) connected to three-phased grid has been investigated. A voltage source inverter (VSI) has been used to connect the photovoltaic system to…
The increasing penetration of photovoltaic (PV) generation in low-voltage distribution networks presents operational challenges, with overvoltages being among the most critical. This study introduces a tool based on Unbalanced Optimal Power…