Related papers: Effect of squeezing on parameter estimation of gra…
During the fifth science run of the Laser Interferometer Gravitational-wave Observatory (LIGO), signals modelling the gravitational waves emitted by coalescing non-spinning compact-object binaries were injected into the LIGO data stream. We…
Gravitational waves modulate the apparent frequencies of other periodic signals. Low-frequency gravitational waves could therefore be detected by observing frequency modulations in signals from higher-frequency sources, e.g., those from…
As two neutron stars merge, they emit gravitational waves that can potentially be detected by earth bound detectors. Matched-filtering based algorithms have traditionally been used to extract quiet signals embedded in noise. We introduce a…
Detections of gravitational waves (GW) in the frequency band 35 Hz to 500 Hz have led to the birth of GW astronomy. Expected signals above 500 Hz, such as the quasinormal modes of lower mass black holes and neutron star mergers signatures…
The future laser interferometric gravitational-wave detectors sensitivity can be improved using squeezed light. In particular, recently a scheme which uses the optical field with frequency dependent squeeze factor, prepared by means of a…
All gravitational-wave observatories (GWOs) have been using the laser wavelength of 1064 nm. Ultra-stable laser devices are at the sites of GEO 600, Kagra, LIGO and Virgo. Since 2019, not only GEO 600 but also LIGO and Virgo have been using…
The astrophysical reach of current and future ground-based gravitational-wave detectors is mostly limited by quantum noise, induced by vacuum fluctuations entering the detector output port. The replacement of this ordinary vacuum field with…
We present a method to characterize the noise in ground-based gravitational-wave observatories such as the Laser Gravitational-Wave Observatory (LIGO). This method uses linear regression algorithms such as the least absolute shrinkage and…
The detection of an electromagnetic transient which may originate from a binary neutron star merger can increase the probability that a given segment of data from the LIGO-Virgo ground-based gravitational-wave detector network contains a…
After the first direct detection of gravitational waves (GW), detection of stochastic background of GWs is an important next step, and the first GW event suggests that it is within the reach of the second-generation ground-based GW…
The gravitational waveform of merging binary neutron stars encodes information about extreme states of matter. Probing these gravitational emissions requires the gravitational-wave detectors to have high sensitivity above 1 kHz. Fortunately…
It is shown in the present Letter that the quantum noise due to high laser intensities in Michelson interferometer for gravitational waves detection can be reduced by sending squeezed vacuum states to the 'dark' port of the interferometer.…
Searching for gravitational waves (GWs) from binary black holes (BBHs) with LIGO and Virgo involves matched-filtering data against a set of representative signal waveforms --- a template bank --- chosen to cover the full signal space of…
We describe a tool we improved to detect excess noise in the gravitational wave (GW) channel arising from its bilinear or nonlinear coupling with fluctuations of various components of a GW interferometer and its environment. We also…
The LIGO and Virgo gravitational-wave observatories have detected many exciting events over the past five years. As the rate of detections grows with detector sensitivity, this poses a growing computational challenge for data analysis. With…
Here I examine how to determine the sensitivity of the LIGO, VIRGO, and LAGOS gravitational wave detectors to sources of gravitational radiation by considering the process by which data are analyzed in a noisy detector. By constructing the…
This paper presents an adaptable, parallelizable method for subtracting linearly coupled noise from Advanced LIGO data. We explain the features developed to ensure that the process is robust enough to handle the variability present in…
The data taken by the advanced LIGO and Virgo gravitational-wave detectors contains short duration noise transients that limit the significance of astrophysical detections and reduce the duty cycle of the instruments. As the advanced…
Low-latency pipelines analyzing gravitational waves from compact binary coalescence events rely on matched filter techniques. Limitations in template banks and waveform modeling, as well as non-stationary detector noise cause errors in…
We describe the implementation of a search for gravitational waves from compact binary coalescences in LIGO and Virgo data. This all-sky, all-time, multi-detector search for binary coalescence has been used to search data taken in recent…