Related papers: Low-Rank Spatial Channel Estimation for Millimeter…
In this letter, we study the reference signal-aided channel estimation concept which is a crucial requirement to address the realistic performance of spatial media-based modulation (SMBM) systems where the radio frequency mirrors are…
In this paper, we investigate the propagation coupling loss (captures all sources of attenuation between serving cell and mobile station (MS)) and geometry metric (GM) (downlink average signal-to-interference plus noise ratio) performance…
Millimeter wave (mmWave) technology is expected to be a major component of 5G wireless networks. Ultra-wide bandwidths of mmWave signals and the possibility of utilizing large number of antennas at the transmitter and the receiver allow…
The IMT 2020 requirements of 20 Gbps peak data rate and 1 millisecond latency present significant engineering challenges for the design of 5G cellular systems. Use of the millimeter wave (mmWave) bands above 10 GHz --- where vast quantities…
In this work, extensive propagation characteristics of short range 240 to 300 GHz terahertz (THz) channels are mapped based on a measurement campaign conducted utilizing a novel, task specific measurement system. The measurement system…
Statistical channel models are instrumental to design and evaluate wireless communication systems. In the millimeter wave bands, such models become acutely challenging; they must capture the delay, directions, and path gains, for each link…
In this paper, adaptive hybrid beamforming methods are proposed for millimeter-wave range massive multiple-input-multiple-output (MIMO) systems considering single carrier wideband transmission in uplink data mode. A statistical analog…
The recently introduced atomic norm minimization (ANM) framework for parameter estimation is a promising candidate towards low overhead channel estimation in wireless communications. However, previous works on ANM-based channel estimation…
This letter investigates the challenge of channel estimation in a multiuser millimeter-wave (mmWave) time-division duplexing (TDD) system. In this system, the base station (BS) employs a multi-antenna uniform linear array (ULA), while each…
Using millimeter-wave (mmWave) bands is expected to provide high data rates through large licensed and unlicensed spectrum. Due to large path loss and sparse scattering propagation properties, proper beam alignment is important in mmWave…
Millimeter-wave (mmWave) and terahertz (THz) communication systems adopt large antenna arrays to ensure adequate receive signal power. However, adjusting the narrow beams of these antenna arrays typically incurs high beam training overhead…
The millimeter wave frequencies (roughly above 10 GHz) offer the availability of massive bandwidth to greatly increase the capacity of fifth generation (5G) cellular wireless systems. However, to overcome the high isotropic pathloss at…
We consider a multiple-input multiple-output (MIMO) relaying boardcast channel in downlink cellular networks, where the base station and the relay stations are both equipped with multiple antennas, and each user terminal has only a single…
Compressed Sensing (CS) based channel estimation techniques have recently emerged as an effective way to acquire the channel of millimeter-wave (mmWave) systems with a small number of measurements. These techniques, however, are based on…
Channel estimation is fundamental to wireless communications, yet it becomes increasingly challenging in massive multiple-input multiple-output (MIMO) systems where base stations employ hundreds of antennas. Traditional least-squares…
Initial access at millimeter wave frequencies is a challenging problem due to hardware non-idealities and low SNR measurements prior to beamforming. Prior work has exploited the observation that mmWave MIMO channels are sparse in the…
Communication at millimeter wave frequencies will be one of the essential new technologies in 5G. Acquiring an accurate channel estimate is the key to facilitate advanced millimeter wave hybrid multiple-input multiple-output (MIMO)…
Millimeter wave (mmWave) multiple-input-multi-output (MIMO) is now a reality with great potential for further improvement. We study full-duplex transmissions as an effective way to improve mmWave MIMO systems. Compared to half-duplex…
We consider the problem of spatial channel covariance matrix (CCM) estimation for intelligent reflecting surface (IRS)-assisted millimeter wave (mmWave) communication systems. Spatial CCM is essential for two-timescale beamforming in…
Holographic massive multiple-input multiple-output (MIMO), in which a spatially continuous surface is being used for signal transmission and reception, have emerged as a promising solution for improving the coverage and data rate of…