Related papers: High performance WR-1.5 corrugated horn based on s…
Reconfigurable reflectarray antennas (RRAs) have rapidly developed with various prototypes proposed in recent literatures. However, designing wideband, multiband, or high-frequency RRAs faces great challenges, especially the lengthy…
Explosive growth in the use of smart wireless devices has necessitated the provision of higher data rates and always-on connectivity, which are the main motivators for designing the fifth generation (5G) systems. To achieve higher system…
Silicon-platelet feedhorn arrays are an established technology at millimeter wavelengths that, for some applications, can provide significant advantages over traditional direct-machined metal feedhorns. The Prime-Cam focal planes operating…
Emerging health-monitor applications, such as information transmission through multi-channel neural implants, image and video communication from inside the body etc., calls for ultra-low active power (<50${\mu}$W) high data-rate,…
Mixed noise, composed of white Gaussian noise (WGN) and impulsive noise (IN), appears in numerous communication scenarios and can severely degrade system performance. In this paper, we optimize the transmitted constellation under mixed…
At the present thesis a prototype antenna is studied. In chapter 1 the antenna's geometry is selected with the supervisor's assistance and its geometrical and dimensional characteristics are outlined. In chapter 2 an extensive theoretical…
In this article, two wide band high-efficiency metasurface structures as a linear-cross polarizer in transmission mode based on asymmetric split-ring resonators (ASRR) are proposed and tested to indicate that this is not a purely…
This report describes the design and proposal of a wireless link capable of broadcasting at 1 Gbps. For this application, isotropic antennas, 256 QAM modulation, and BER level less than 1e-5, without using error correction coding, were…
Reconfigurable Intelligent Surfaces (RIS) have been identified as a potential ingredient to enhance the performance of contemporary wireless communication and sensing systems. Yet, most of the existing devices are either costly or not…
Next-generation wireless systems aim to enable on-demand connectivity through dynamic spectrum utilization. Motivated by this vision, this paper investigates the propagation characteristics and MIMO performance of the upper mid-band,…
5G wireless networks are expected to support Ultra Reliable Low Latency Communications (URLLC) traffic which requires very low packet delays ( < 1 msec.) and extremely high reliability ($\sim$99.999\%). In this paper we focus on the design…
This article presents a fully 3D-printed wideband metasurface folded reflectarray antenna (MFRA) operating in the millimeter-wave n257 band. The proposed MFRA integrates a novel polarization-rotating reflective metasurface (RMS), a compact…
A low cost solution for constructing receiver signal points is investigated that combines a large number of constrained radio frequency (RF) frontends with a limited number of full RF chains. The constrained RF front ends have low cost and…
Up-to-date network telemetry is the key enabler for resource optimization by capacity scaling, fault recovery, and network reconfiguration among other means. Reliable optical performance monitoring in general and, specifically, the…
This review explores the development of spin-wave technology, highlighting magnonics as a promising route for radio frequency (RF) communication systems. The rollout of 5G and the upcoming 6G networks intensifies the demand for devices that…
In this brief, a novel harmonic-backscatter-rectifier (HBR) is introduced for simultaneous rectification and harmonic-based uplink. The proposed (HBR) employs a rectifier to generate both DC power and the harmonic carriers for…
We report ring resonators on a silicon germanium on silicon platform operating in the mid-infrared wavelength range around 3.5 - 4.6 {\mu}m with quality factors reaching up to one million. Advances in fabrication technology enable us to…
This paper introduces a highly efficient rectenna (rectifying antenna) using a binary optimization algorithm. A novel pixelated receiving antenna has been developed to match the diode impedance of a rectifier, eliminating the need for a…
High power fiber lasers operating at the 1.5micron wavelength region have attractive features like eye-safety and atmospheric transparency, and cascaded Raman fiber lasers offer a convenient method to obtain high power sources at these…
We have developed radiative transfer models of the radio emission from colliding-wind binaries (CWB) based on a hydrodynamical treatment of the wind-collision region (WCR). The archetype of CWB systems is the 7.9-yr period binary WR140,…