Related papers: On the calibration of direct-current current trans…
As a result of improvements in power semiconductors, moderate frequency switching supplies can now provide the hundreds of amps typically required by accelerators with zero-to-peak noise in the kHz region ~0.06% in current or voltage mode.…
Rapid developments in power distribution systems and renewable energy have widened the applications of dc--dc buck--boost converters in dc voltage regulation. Applications include vehicular power systems, renewable energy sources that…
Calibration is one area in measurement where our country is still in the process of improvement. The absence of confirmed approaches and actions for identifying the features of calibration baths by numerous laboratories disallowed them to…
To test and calibrate various detectors in nuclear and high energy physics experiments, a general purposed calibration instrument has been developed. All information including timing, amplitude and charge of signals can be directly obtained…
Current-fed half bridge converter with bidirectional switches on ac side and a full bridge converter on dc side of a high frequency transformer is an optimal topology for single stage galvanically isolated ac-dc converter for onboard…
The purpose of this project was to design and implement a pipeline Analog-to-Digital Converter using 0.35um CMOS technology. Initial requirements of a 25-MHz conversion rate and 8-bits of resolution where the only given ones. Although…
On-silicon inductors using a bulk 0.18 {\mu}m CMOS process have been designed. By shunting different metal layers in parallel, inductor values and quality factors were simulated. Selected inductors were then employed in two open-loop buck…
The electronic response of a telescope under direct illumination by a point-like light source is based on photon counting. With the data obtained using the SNDICE light source and the Megacam camera on the CFHT telescope, we show that the…
In this study, we evaluate the suitability of using DC-biased aluminium resonators as low-frequency kinetic inductance detectors operating in the frequency range of 50 - 120 GHz. Our analysis routine for supercurrent-biased resonators is…
We consider the problem of guaranteeing that the transient voltages and currents stay within prescribed bounds in Direct Current (DC) microgrids, when the controller does not have access to accurate system dynamics due to the load being…
Ultra high dose rate electron beams also known as FLASH radiotherapy is becoming of importance in several preclinial cancer treatment studies. However, due to the dose rate used during the irradiation sessions, no real time dose monitoring…
We present an innovative technique which allows the simultaneous measurement of the dielectric constant of a material at many frequencies, spanning a four orders of magnitude range chosen between 10 --2 Hz and 10 4 Hz. The sensitivity and…
At National Institute of Metrological Research (INRIM), a selectable-value Transportable High dcVoltage Standard (THVS) operating in the range from 10 V to 100 V in steps of 10 V, was developed. This Standard was built to cover the lack of…
We show how to determine the electric and weak dipole moments of the top quark simultaneously and independently from $e^+e^-\to t\bar t$ at $\sqrt{s}=500$ GeV NLC. To obtain the best accuracies with which the dipole moments can be measured,…
We describe the design and performance of a series of fast, precise current sensing noise thermometers. The thermometers have been fabricated with a range of resistances from 1.290 $\Omega$ down to 0.2 m$\mathrm{\Omega}$. This results in…
In this paper an algorithm for transient simulation of switching converters using prediction and correction to calculate duty ratio is proposed. It provides large signal simulation on the level of averaged currents and voltages in the…
The use of differential phase contrast (DPC) in scanning transmission electron microscopy (STEM) has shown much promise for directly investigating the functional properties of a material system, leveraging the natural coupling between the…
This paper describes the design of a low-cost USB-controlled potentiostat/galvanostat which can measure or apply potentials in the range of +/-8V, and measure or apply currents ranging from nanoamps to max. +/-25 mA. Precision is excellent…
A pico-ampere sensitive electrochemical sensor signal acquisition chain consisting of a multi-channel bidirectional current-mirror based potentiostat and a multiplexed current-input delta-sigma ($\Delta \Sigma$) ADC is presented.…
The ability to conduct electric current without dissipating energy is a property of superconductors that is used in magnetic systems utilized in healthcare, natural sciences, and ongoing global projects in nuclear fusion and aviation. The…