Related papers: Large Photocathode Photodetectors Using Photon Amp…
Cavity-optomechanics enables photon-phonon interaction and correlations by harnessing the radiation-pressure force. Here, we realize a ``cavity-in-a-membrane'' optomechanical architecture which allows detection of the motion of…
Bioluminescence detection requires single-photon sensitivity, extremely low detection limits and wide dynamic range. Such performances were traditionally assured by photomultiplier-tubes based systems. However, development of novel…
We propose a scheme to enhance the single- and two-photon blockade effect significantly in a standard optomechanical system (OMS) via optical parametric amplification (OPA). The scheme does not rely on the strong single-photon…
Cavity optoelectromechanical regenerative amplification is demonstrated. An optical cavity enhances mechanical transduction, allowing sensitive measurement even for heavy oscillators. A 27.3 MHz mechanical mode of a microtoroid was…
Phase-sensitive detection is the essential projective measurement for measurement-based continuous-variable quantum information processing. The bandwidth of conventional electrical phase-sensitive detectors is up to several gigahertz, which…
We consider the use of single-photon counting detectors in coherence-domain imaging. Detectors operated in this mode exhibit reduced noise, which leads to increased sensitivity for weak light sources and weakly reflecting samples. In…
Excitons in atomically-thin semiconductors interact very strongly with electromagnetic radiation and are necessarily close to a surface. Here, we exploit the deep-subwavelength confinement of surface plasmon polaritons (SPPs) at the edge of…
Single-photon detectors are an essential part of the toolbox of modern quantum optics for implementing quantum technologies and enabling tests of fundamental physics. The low energy of microwave photons, the natural signal path for…
Compressive imaging using coded apertures (CA) is a powerful technique that can be used to recover depth, light fields, hyperspectral images and other quantities from a single snapshot. The performance of compressive imaging systems based…
We successfully developed a new photomultiplier tube (PMT) with a three-inch diameter, convex-shaped photocathode, R13111. Its prominent features include good performance and ultra-low radioactivity. The convex-shaped photocathode realized…
Optical fiber tapers are used to collect photoluminescence emission at ~1.5 um from photonic crystal cavities fabricated in erbium doped silicon nitride on silicon. Photoluminescence collection via fiber taper is enhanced 2.5 times relative…
Silicon photomultipliers are photon-number-resolving detectors endowed with hundreds of cells enabling them to reveal high-populated quantum optical states. In this paper, we address such a goal by showing the possible acquisition…
All optical detectors to date annihilate photons upon detection, thus excluding repeated measurements. Here, we demonstrate a robust photon detection scheme which does not rely on absorption. Instead, an incoming photon is reflected off an…
Dual-comb microscopy (DCM), based on a combination of dual-comb spectroscopy (DCS) with two-dimensional spectral encoding (2D-SE), is a promising method for scan-less confocal laser microscopy giving an amplitude and phase image contrast…
A hollow cylindrical micron-scale structure is proposed to enhance and manipulate the laser plasma interaction. It is shown through 3-D particle-in-cell simulations that the incident laser pulse intensity is enhanced within the tube. A…
The paper reviews recent progress in photodetectors, discussing vacuum-based detectors, semiconductor sensors, and gas-based detectors. The emphasis in this review is on the detection of low light levels, enhanced timing resolution, and…
Enhancing photon detection efficiency and time resolution in photodetectors in the entire visible range is critical to improve the image quality of time-of-flight (TOF)-based imaging systems and fluorescence lifetime imaging (FLIM). In this…
In gamma ray imaging, a scintillation crystal is typically used to convert the gamma radiation into visible light. Photosensors are used to transform this light into measurable signals. Several types of photosensors are currently in use…
Organic photodetectors (OPDs) possess bright prospects in applications of medical imaging and wearable electronics due to the advantages such as low cost, good biocompatibility, and good flexibility. Photomultiplication OPDs (PM-OPDs)…
Squeezed vacuum field can be amplified or deamplified when it is injected, as the signal beam, into a phase-sensitive optical parametric amplifier (OPA) inside an optical cavity. The spectral features of the reflected quantized signal field…