Related papers: GRAVITY: the Calibration Unit
An accurate and extensive Inter-laboratory comparison between the laboratory for the calibration of multifunction electrical instruments of the National Institute of Metrology Research (INRIM) and a secondary high level electrical…
The center of gravity as an algorithm for position measurements is analyzed for a two-dimensional geometry. Several mathematical consequences of discretization for various types of detector arrays are extracted. Arrays with rectangular,…
This article gives an overview of potential upgrades of second generation gravitational wave detectors and the required key technologies to improve the limiting noise sources. In addition the baseline design of the Einstein Telescope, a…
We propose two schemes for implementing graph states useful for fault-tolerant topological measurement-based quantum computation in 2D optical lattices. We show that bilayer cluster and surface code states can be created by global…
Pulsed UV lasers can provide useful "testbeams" for observatories that use optical detectors, especially fluorescence detectors, to measure high energy cosmic-rays. The light observed by the detector is proportional to the energy of the…
The on-board Scientific Trigger Unit (UTS) is designed to detect Gamma Ray Bursts (GRBs) in real-time, using the data produced by the ECLAIRs camera, foreseen to equip the future French-Chinese satellite mission SVOM (Space-based Variable…
In this paper we present a novel algorithm for onboard radial distortion correction for unmanned aerial vehicles (UAVs) equipped with an inertial measurement unit (IMU), that runs in real-time. This approach makes calibration procedures…
In the initial phase of the Swiss Light Source, four insertion devices will be installed. The control system for all the ID's follows an uniform concept to allow a rapid installation schedule, while at the same time allowing for a variety…
Gamma ray bursts (GRBs) have recently attracted much attention as a possible way to extend the Hubble diagram to very high redshift. To this aim, the luminosity (or isotropic emitted energy) of a GRB at redshift z must be evaluated from a…
POLAR is a compact space-borne detector designed to perform reliable measurements of the polarization for transient sources like Gamma-Ray Bursts in the energy range 50-500keV. The instrument works based on the Compton Scattering principle…
An astatized symmetrical vertical pendulum is monitoring torque {\Gamma}(M) resulting of gravitational attractions exerted by two external masses M moving up down. Local gravity field g produce the main pendulum restoring torque combined…
The intrinsic alignment (IA) of galaxies has been shown to be a significant barrier to precision cosmic shear measurements. (Zhang, 2010, ApJ, 720, 1090) proposed a self-calibration technique for the power spectrum to calculate the induced…
HERA is a highly-redundant transit interferometer with 14\,m-diameter parabolic dish elements. We exploit the fact that the Galactic centre transits through the main beam of the telescope to attempt a conventional self-calibration approach…
Submillimeter (submm) integral field units (IFUs) utilising kinetic inductance detectors (KIDs) are a promising instrument architecture for the study of galaxies, galaxy clusters, and the large-scale structure of the Universe. In order to…
A considerable amount of research is concerned with the generation of realistic sensor data. LiDAR point clouds are generated by complex simulations or learned generative models. The generated data is usually exploited to enable or improve…
(abridged for arXiv) With the first direct detection of gravitational waves, the Advanced Laser Interferometer Gravitational-wave Observatory (LIGO) has initiated a new field of astronomy by providing an alternate means of sensing the…
In this paper, we present a user-friendly LiDAR-camera calibration toolkit that is compatible with various LiDAR and camera sensors and requires only a single pair of laser points and a camera image in targetless environments. Our approach…
ComPair, the prototype of the All-sky Medium Energy Gamma-ray Observatory (AMEGO) mission concept, is a combined Compton imager and pair production telescope. It consists of four subsystems: a double-sided silicon strip detector (DSSD)…
As the main detector of the GECAM satellite, the calibration of the energy response and detection efficiency of the GRD detector is the main content of the ground-based calibration. The calibration goal requires the calibrated energy points…
This paper explains the Unimodular gauge fixing of gravity and supergravity in the framework of a perturbative BRST construction. The unphysical sector contains additional BRST-exact quartets to suppress possible ambiguities and impose both…