Related papers: Microwave-induced spin currents in ferromagnetic-i…
The spin Seebeck effect is a spin-motive force generated by a temperature gradient in a ferromagnet that can be detected via normal metal contacts through the inverse spin Hall effect [K. Uchida {\it et al.}, Nature {\bf 455}, 778-781…
Spin waves in magnetic films are affected by the vicinity to a superconductor. Here we focus on a bilayer stack made of an insulating Yttrium Iron Garnet (YIG) film and a high-$T_c$ YBCO superconducting planar resonator and report microwave…
We investigated spin injection by spin pumping from a spin-injector(NiFe) into a spin-sink to detect spin fluctuations in the spin-sink. By scanning the ordering-temperature of several magnetic transitions, we found that enhanced spin…
The power flow process mediated by spin current in the bilayer device consisting of ferromagnetic metal (FM) and non-magnetic metal (NM) layers is examined by realizing experimental evaluations for each process from the microwave absorption…
Thermal-bias-induced spin angular momentum transfer between a paramagnetic metal and ferromagnetic insulator is studied theoretically based on the stochastic Landau-Lifshitz-Gilbert (LLG) phenomenology. Magnons in the ferromagnet establish…
Spin pumping by ferromagnetic resonance is one of the most common technique to determine spin hall angles, Edelstein lengths or spin diffusion lengths of a large variety of materials. In recent years, rising concerns have appeared regarding…
Precessing magnetization in a thin film magnetic insulator pumps spins into adjacent metals; however, this phenomenon is not quantitatively understood. We present a theory for the dependence of spin-pumping on the transverse mode number and…
We measure electrically detected ferromagnetic resonance in microdevices patterned from ultra-thin Co/Pt bilayers. Spin pumping and rectification voltages are observed and distinguished via their angular dependence. The spin-pumping voltage…
We propose inducing Bose-Einstein condensation of magnons in a magnetic insulator by a heat flow oriented toward its boundary. At a critical heat flux, the oversaturated thermal gas of magnons accumulated at the boundary precipitates the…
It is demonstrated that upon pulsed microwave excitation, the temporal behavior of a spin-wave induced inverse spin Hall voltage in a magnetic insulator-nonmagnetic metal structure is distinctly different from the temporal evolution of the…
The influence of an asymmetric in-plane magnetic anisotropy on the thermally activated spin current is studied theoretically for two different systems; (i) the system consisting of a ferromagnetic insulator in a direct contact with a…
We theoretically investigate spin transport at the interface between the ferromagnetic insulator(FI) and a superconductor(SC). Considering a simple FI-SC interface model, we derive formulas for the spin current and spin-current noise…
We investigate the spin Seebeck effect and spin pumping in a junction between a ferromagnetic insulator and a magnetic impurity deposited on a normal metal. By the numerical renormalization group calculation, we show that spin current is…
A new current induced spin-torque transfer effect has been observed in a single ferromagnetic layer without resorting to multilayers. At a specific current density of one polarity injected from a point contact, abrupt resistance changes due…
Spin current injection from sputtered yttrium iron garnet (YIG) films into an adjacent platinum layer has been investigated by means of the spin pumping and the spin Seebeck effects. Films with a thickness of 83 and 96 nanometers were…
We study spin pumping in a $\mathrm{Y_3Fe_5O_{12}(YIG)/Pt/Ni_{81}Fe_{19}(Py)}$ trilayer film by means of the inverse spin Hall effect (ISHE). When the ferromagnets are not excited simultaneously by a microwave, ISHE-induced voltage is of…
We investigate the inverse spin Hall voltage of a 10nm thin Pt strip deposited on the magnetic insulators Y3Fe5O12 (YIG) and NiFe2O4 (NFO) with a temperature gradient in the film plane. We observe characteristics typical of the spin Seebeck…
When a charge current is applied to a junction comprising two different conductors, its temperature increases or decreases depending on the direction of the charge current. This phenomenon is called the Peltier effect, which is used in…
The spin Seebeck effect (SSE) in ferrimagnetic insulators (FMI) provides a simple method of using heat to manipulate magnons, which could be used as carriers of information and energy conversion. However, a theory that can quantitively…
Spin Seebeck effect (SSE) holds promise for new spintronic devices with low-energy consumption. The underlying physics, essential for a further progress, is yet to be fully clarified. This study of the time resolved longitudinal SSE in the…