Related papers: Variable viscosity condition in the modeling of a …
We present a study of sliding friction for rigid triangular steel sliders on soft rubber substrates under both lubricated and dry conditions. For rubber surfaces lubricated with a thin film of silicone oil, the measured sliding friction at…
The lubrication theory is mostly concerned with the behavior of a lubricant flowing through a narrow gap. Motivated by the experimental findings from the tribology literature, we take the lubricant to be micropolar fluid and study its…
A theoretical model is proposed for low temperature friction between two smooth rigid solid surfaces separated by lubricant molecules, admitting their deformations and rotations. Appearance of different modes of energy dissipation (by…
We study the lubrication of fluid-immersed soft interfaces and show that elastic deformation couples tangential and normal forces and thus generates lift. We consider materials that deform easily, due to either geometry (e.g. a shell) or…
Friction between contacting solid surfaces is a dominant force on the micro-scale and a major consideration in the design of MEMS. Non-contact fluid bearings have been investigated as a way to mitigate this issue. Here we discuss a new…
We describe theoretically ``electrolubrication'' in liquid mixtures, the phenomenon where an electric field applied transverse to the confining surfaces leads to concentration gradients that alter the flow profile significantly. When the…
We provide numerical simulations of an incompressible pressure-thickening and shear-thinning lubricant flowing in a plane slider bearing. We study the influence of several parameters, namely the ratio of the characteristic lengths…
The Synchronized Molecular-Dynamics simulation which was recently proposed by authors [Phys. Rev. X {\bf 4}, 041011 (2014)] is applied to the analysis of polymer lubrication between parallel plates. The rheological properties,…
We explore the instabilities developed in a fluid in which viscosity depends on temperature. In particular, we consider a dependency that models a very viscous (and thus rather rigid) lithosphere over a convecting mantle. To this end, we…
Lubrication flows between two solid surfaces can be found in a variety of biological and engineering settings. In many of these systems, the lubricant exhibits viscoelastic properties, which modify the associated lubrication forces. Here,…
Lubrication flows appear in many applications in engineering, biophysics, and in nature. Separation of surfaces and minimisation of friction and wear is achieved when the lubrication fluid builds up a lift force. In this paper we analyse…
We study rubber sliding friction on hard lubricated surfaces. We show that even if the hard surface appears smooth to the naked eye, it may exhibit short wavelength roughness, which may give the dominant contribution to rubber friction.…
When a rubber block is sliding on a hard rough substrate, the substrate asperities will exert time-dependent deformations of the rubber surface resulting in viscoelastic energy dissipation in the rubber, which gives a contribution to the…
Rubber friction on wet rough substrates at low velocities is typically 20-30% smaller than for the corresponding dry surfaces. We show that this cannot be due to hydrodynamics and propose a novel explanation based on a sealing effect…
We investigate the effective friction encountered by a mass sliding on a granular layer as a function of bed thickness and boundary roughness conditions. The observed friction has minima for a small number of layers before it increases and…
The rolling motion of a rigid cylinder on an inclined flat viscous surface is investigated and the nonlinear resistance force against rolling, $F_R(v)$, is derived. For small velocities $F_R(v)$ increases with velocity due to increasing…
Ball bearings are commonly used to reduce the friction in rotating mechanical components. The present work reports improved numerical approaches to model bearing thermal conductance in the absence of convection. We start by modeling the…
Rubber friction is of major practical importance in applications such as tires, rubber seals, and footwear. This review article focuses on the theory and experimental studies of rubber friction on substrates with random roughness. We…
Using molecular dynamics based on Langevin equations with a coordinate- and velocity-dependent damping coefficient, we study the frictional properties of a thin layer of "soft" lubricant (where the interaction within the lubricant is weaker…
A deterministic theory describing the behavior of an ultrathin lubricant film between two atomically-smooth solid surfaces is proposed. For the description of lubricant state the parameter of excess volume arising due to chaotization of…