Related papers: Training Sequence Design for Feedback Assisted Hyb…
A major source of difficulty when operating with large arrays at mmWave frequencies is to estimate the wideband channel, since the use of hybrid architectures acts as a compression stage for the received signal. Moreover, the channel has to…
In future practical deployments of massive multi-input multi-output (MIMO) systems, the number of radio frequency (RF) chains at the base stations (BSs) may be much smaller than the number of BS antennas to reduce the overall expenditure.…
Federated learning enables cooperative training among massively distributed clients by sharing their learned local model parameters. However, with increasing model size, deploying federated learning requires a large communication bandwidth,…
We develop sparse array receive beamformer design methods achieving maximum signal-to-interference plus noise ratio (MaxSINR) for wideband sources and jammers. Both tapped delay line (TDL) filtering and the DFT realizations to wideband…
This paper proposes a new transmission strategy for the multiuser massive multiple-input multiple-output (MIMO) systems, including uplink/downlink channel estimation and user scheduling for data transmission. A discrete Fourier transform…
The WLAN packet format has a short training field (STF) for synchronization followed by a long training field (LTF) for channel estimation. To enable MIMO channel estimation, the LTF is repeated as many times as the number of spatial…
Multiple-input multiple-output (MIMO) wireless systems conventionally use high-resolution analog-to-digital converters (ADCs) at the receiver side to faithfully digitize received signals prior to digital signal processing. However, the…
Radio frequency (RF) chain circuits play a major role in digital receiver architectures, allowing passband communication signals to be processed in baseband. When operating at high frequencies, these circuits tend to be costly. This…
A near-field wideband communication system is investigated in which a base station (BS) employs an extra-large scale antenna array (ELAA) to serve multiple users in its near-field region. To facilitate near-field multi-user beamforming and…
We propose novel hybrid beamforming schemes for the terahertz (THz) wireless system where a multi-antenna base station (BS) communicates with a multi-antenna user over frequency selective fading. Here, we assume that the BS employs…
The combination of Terahertz (THz) and massive multiple-input multiple-output (MIMO) is promising to meet the increasing data rate demand of future wireless communication systems thanks to the huge bandwidth and spatial degrees of freedom.…
We investigate a general channel estimation problem in the massive multiple-input multiple-output (MIMO) system which employs the hybrid analog/digital precoding structure with limited radio-frequency (RF) chains. By properly designing RF…
The superimposed pilot transmission scheme offers substantial potential for improving spectral efficiency in MIMO-OFDM systems, but it presents significant challenges for receiver design due to pilot contamination and data interference. To…
Cell-free Massive MIMO (multiple-input multiple-output) refers to a distributed Massive MIMO system where all the access points (APs) cooperate to coherently serve all the user equipments (UEs), suppress inter-cell interference and mitigate…
A multiple antenna broadcast channel with perfect channel state information at the receivers is considered. If each receiver quantizes its channel knowledge to a finite number of bits which are fed back to the transmitter, the large…
Hybrid multiple-antenna transceivers, which combine large-dimensional analog pre/postprocessing with lower-dimensional digital processing, are the most promising approach for reducing the hardware cost and training overhead in massive MIMO…
Accurate downlink channel information is crucial to the beamforming design, but it is difficult to obtain in practice. This paper investigates a deep learning-based optimization approach of the downlink beamforming to maximize the system…
Large-scale MIMO systems have been considered as one of the possible candidates for the next-generation wireless communication technique, due to their potential to provide significant higher throughput than conventional wireless systems.…
Massive MIMO systems can achieve high spectrum and energy efficiency in downlink (DL) based on accurate estimate of channel state information (CSI). Existing works have developed learning-based DL CSI estimation that lowers uplink feedback…
Beamforming with large-scale antenna arrays has been widely used in recent years, which is acknowledged as an important part in 5G and incoming 6G. Thus, various techniques are leveraged to improve its performance, e.g., deep learning,…