Related papers: All-Digital Self-interference Cancellation Techniq…
Radio frequency transceivers operating in in-band full-duplex or frequency-division duplex mode experience strong transmitter leakage. Combined with receiver nonlinearities, this causes intermodulation products in the baseband, possibly…
Orthogonal delay-Doppler division multiplexing (ODDM) modulation has recently gained significant attention as a promising candidate to promote the communication reliability in high-mobility environments. Low complexity signal detection is…
In this paper, we study virtual full-duplex (FD) buffer-aided relaying to recover the loss of multiplexing gain caused by half-duplex (HD) relaying in a multiple relay network, where each relay is equipped with a buffer and multiple…
This paper proposes a novel scheme for mitigating strong interferences, which is applicable to various wireless scenarios, including full-duplex wireless communications and uncoordinated heterogenous networks. As strong interferences can…
Full duplex (FD) systems suffer from very high hardware cost and high power consumption to mitigate the self-interference (SI) in the analog domain. Moreover, in millimeter wave (mmWave) they rely on hybrid beamforming (HYBF) as a signal…
Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems have been considered as one of the primary candidates for the fifth generation (5G) and beyond 5G wireless communication networks to satisfy the ever-increasing…
In this letter, we propose a modified version of Fast Independent Component Analysis (FICA) algorithm to solve the self-interference cancellation (SIC) problem in In-band Full Duplex (IBFD) communication systems. The complex mixing problem…
Millimeter-wave (mmWave) communications and cell densification are the key techniques for the future evolution of cellular systems beyond 5G. Although the current mmWave radio designs are focused on hybrid digital and analog receiver array…
Radio interferometric observations are less susceptible to radio frequency interference (RFI) than single dish observations. This is primarily due to : (1)fringe-frequency averaging at the correlator output and (2) bandwidth decorrelation…
Analog self-interference cancellation (A-SIC) plays a crucial role in the implementation of in-band full-duplex (IBFD) radios, due to the fact that the inherent transmit (Tx) noise can only be addressed in the analog domain. It is thus…
In this paper, we present a new receiver design, which significantly improves performance in the Internet of Things networks such as LoRa, i.e., having a chirp spread spectrum modulation. The proposed receiver is able to demodulate multiple…
The maximum information rates for bandlimited channels with direct detection are achieved with joint detection and decoding (JDD), but JDD is often too complex to implement. Two receiver structures are studied to reduce complexity: separate…
This letter considers secrecy simultaneous wireless information and power transfer (SWIPT) in full duplex systems. In such a system, full duplex capable base station (FD-BS) is designed to transmit data to one downlink user and concurrently…
The necessity of accurate channel estimation for Successive and Parallel Interference Cancellation is well known. Iterative channel estimation and channel decoding (for instance by means of the Expectation-Maximization algorithm) is…
Multiple-input multiple-output (MIMO) mmWave devices broadcast multiple spatially-separated data streams simultaneously in order to increase data transfer rates. Data transfer can, however, be compromised by interference. Conventional…
Recent work has shown the feasibility of single-channel full-duplex wireless physical layer, allowing nodes to send and receive in the same frequency band at the same time. In this report, we first design and implement a real-time…
To increase the spectral efficiency of wireless networks without requiring full-duplex capability of user devices, a potential solution is the recently proposed three-node full-duplex mode. To realize this potential, networks employing…
Millimeter wave (mmWave) and terahertz MIMO systems rely on pre-defined beamforming codebooks for both initial access and data transmission. However, most of the existing codebooks adopt pre-defined beams that focus mainly on improving the…
We investigate characteristics of radio frequency interference (RFI) signals that can affect the excision potential of some interference mitigation algorithms. The techniques considered are those that modify signals from auxiliary reference…
A new adaptive receiver design for the Multicarrier (MC) DS-CDMA is proposed employing successive interference cancellation (SIC) architecture. One of the main problems limiting the performance of SIC in MC DS-CDMA is the imperfect…