Related papers: Turbulent heat transfer in a channel flow at trans…
Direct numerical simulations of turbulent heat transfer in fully-developed channel flows have been performed in a range of friction Reynolds number between 60 and 180, based on the friction velocity and the channel half width $\delta$, with…
Results of direct numerical simulations (DNS) of porous-wall turbulent flows in open channels with conjugate heat transfer are reported in this work. For the conductive porous walls considered here, the change in heat transfer is not…
The object of this paper is to study the influence of dispersed micrometer size particles on turbulent heat transfer mechanisms in wall-bounded flows. The strategic target of the current research is to set up a methodology to size and…
Using the previously developed model to describe laminar/turbulent states of a viscous fluid flow, which treats the flow as a collection of coherent structures of various size (Chekmarev, Chaos, 2013, 013144), the statistical temperature of…
The transitional regime of plane channel flow is investigated {above} the transitional point below which turbulence is not sustained, using direct numerical simulation in large domains. Statistics of laminar-turbulent spatio-temporal…
Turbulent stripe, which would occur in turbulent channel flows at transitional Reynolds numbers, was studied experimentally by flow visualization using reflective flake particles. In a range of bulk mean Reynolds number Re = 1700-2000, the…
This study analyzes the behavior of a differentially heated channel flow by means of a direct numerical simulations (DNS) with variable thermophysical properties under low-speed conditions focusing on the impact of the temperature gradient…
Contrasting with free shear flows presenting velocity profiles with inflection points which cascade to turbulence in a relatively mild way, wall bounded flows are deprived of (inertial) instability modes at low Reynolds numbers and become…
Direct numerical simulations (DNS) of fully-developed turbulent channel flows for very low Reynolds numbers have been performed with a larger computational box sizes than those of existing DNS. The friction Reynolds number was decreased…
Heat transfer by large deformable drops in a turbulent flow is a complex and rich in physics system, in which drops deformation, breakage and coalescence influence the transport of heat. We study this problem coupling direct numerical…
We present direct numerical simulation results of turbulent open channel flow at bulk Reynolds numbers up to 12000, coupled with (passive) scalar transport at Schmidt numbers up to 200. Care is taken to capture the very large scale motions…
Direct numerical simulations are performed of turbulent forced convection in a half channel flow with wall oscillating either as a spanwise plane oscillation or to generate a streamwise travelling wave. The friction Reynolds number is fixed…
Spatial and spectral energy exchanges associated with the turbulence kinetic energy per unit mass, or half-trace of the velocity covariance tensor, are studied in an anisothermal low Mach number turbulent channel flow. The temperatures of…
Passive scalars in turbulent channel flows are investigated as canonical problem for heat and mass transfer in turbulent boundary-layer flows. The one-dimensional turbulence model is used to numerically investigate the Schmidt and Reynolds…
In this thesis, a variable speed heat conducting cylinder is positioned in the middle of a rectangular channel with an active flow modification system to demonstrate a numerical study of steady two-dimensional mixed convention heat transfer…
The large structures in the outer layer of turbulent wall flows are of great physical importance, because they contain a substantial fraction of the streamwise kinetic energy and of the Reynolds stresses. Nevertheless, the organization of…
The turbulence statistics of the intermittent region in a supersonic turbulent boundary layer are studied by direct numerical simulation. Recently, Kwon et al. (2016) have shown that this intermittent behavior, consisting of the coexistence…
Intermittent turbulent-laminar patterns characterize the transition to turbulence in pipe, plane Couette and plane channel flows. The time evolution of turbulent-laminar bands in plane channel flow is studied via direct numerical…
We introduce a minimal model of energy transfer through scales to describe, at a qualitative level, the subcritical transition between laminar and turbulent flows, viewed in a statistical physics framework as a discontinuous absorbing phase…
Heated pipe flow is widely used in thermal engineering applications, but the presence of buoyancy force can cause intermittency, or multiple flow states at the same parameter values. Such changes in the flow lead to substantial changes in…