Related papers: Reference Receiver Based Digital Self-Interference…
The flexible duplex (FD) technique, including dynamic time-division duplex (D-TDD) and dynamic frequency-division duplex (D-FDD), is regarded as a promising solution to achieving a more flexible uplink/downlink transmission in 5G-Advanced…
A digital-assisted photonic analog wideband radio-frequency multipath self-interference cancellation (SIC) and frequency downconversion method based on a dual-drive Mach-Zehnder modulator and the recursive least square (RLS) algorithm is…
This thesis considers channel estimation and multiuser (MU) data transmission for massive MIMO systems with fully digital/hybrid structures in mmWave channels. It contains three main contributions. In this thesis, we first propose a…
Radio frequency (RF) chain circuits play a major role in digital receiver architectures, allowing passband communication signals to be processed in baseband. When operating at high frequencies, these circuits tend to be costly. This…
For a K-user interference channel, the degree of freedom (DoF) which can be achieved through interference alignment (IA) is constrained to signal space dimension governed by the number of Tx/Rx antennas. To overcome this problem, IA can be…
The potential of deploying large-scale antenna arrays in future wireless systems has stimulated extensive research on hybrid transceiver designs aiming to approximate the optimal fully-digital schemes with much reduced hardware cost and…
This paper considers a $K$-user multiple-input single-output (MISO) interference channels for simultaneous wireless information and power transfer (SWIPT), where each multi-antenna transmitter serves a single-antenna receiver per user pair.…
We study the multi-user massive multiple-input-single-output (MISO) and focus on the downlink systems where the base station (BS) employs hybrid analog-digital precoding with low-cost 1-bit digital-to-analog converters (DACs). In this…
Millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems have been considered as one of the primary candidates for the fifth generation (5G) and beyond 5G wireless communication networks to satisfy the ever-increasing…
Digital receivers are required to recover the transmitted symbols from their observed channel output. In multiuser multiple-input multiple-output (MIMO) setups, where multiple symbols are simultaneously transmitted, accurate symbol…
In this paper, taking the view that a linear parallel interference canceller (LPIC) can be seen as a linear matrix filter, we propose new linear matrix filters that can result in improved bit error performance compared to other LPICs in the…
Reconfigurable intelligent surface (RIS) technique stands as a promising signal enhancement or signal cancellation technique for next generation networks. We design a novel passive beamforming weight at RISs in a multiple-input…
A full-duplex two-way relay channel with multiple antennas is considered. For this three-node network, the beamforming design needs to suppress self-interference. While a traditional way is to apply zero-forcing for self-interference…
We study multi-user transmission and detection schemes for a multi-access relay network (MARN) with linear constraints at all nodes. In a $(J, J_a, R_a, M)$ MARN, $J$ sources, each equipped with $J_a$ antennas, communicate to one…
We consider a full-duplex decode-and-forward system, where the wirelessly powered relay employs the time-switching protocol to receive power from the source and then transmit information to the destination. It is assumed that the relay node…
This paper presents a kernel-based adaptive filter that is applied for the digital domain self-interference cancellation (SIC) in a transceiver operating in full-duplex (FD) mode. In FD, the benefit of simultaneous transmission and…
Previously, we presented a non-magnetic, nonreciprocal N-path-filter-based circulator-receiver (circ.-RX) architecture for full-duplex (FD) wireless which merges a commutation-based linear periodically-time-varying (LPTV) non-magnetic…
In this paper, we consider a reconfigurable intelligent surface (RIS)-assisted multiple-input multiple-output communication system with multiple antennas at both the base station (BS) and the user. We plan to maximize the achievable rate…
Building on the previous work on interference mitigation, this paper introduces a modular recommender system that automatically selects the most effective interference mitigation strategy based on the interference characteristics present in…
We design a jamming-resistant receiver scheme to enhance the robustness of a massive MIMO uplink system against jamming. We assume that a jammer attacks the system both in the pilot and data transmission phases. The key feature of the…