Related papers: Cooperative Beamforming for Cognitive Radio-Based …
Beamformers often trade off white noise gain against the ability to suppress interferers. With distributed microphone arrays, this trade-off becomes crucial as different arrays capture vastly different magnitude and phase differences for…
Interference alignment is a signaling technique that provides high multiplexing gain in the interference channel. It can be extended to multi-hop interference channels, where relays aid transmission between sources and destinations. In…
In this paper, the problem of joint design of Spectrum Sensing (SS) and receive beamforming (BF), with reference to a Cognitive Radio (CR) system, is considered. The aim of the proposed design is the maximization of the achievable average…
We consider a network of agents that locate themselves in an environment through sensor measurements and aim to transmit a message signal to a base station via collaborative beamforming. The agents' sensor measurements result in…
Radio Spectrum is most precious and scarce resource and must be utilized efficiently and effectively. Cognitive radio is the promising solutions for the optimum utilization of the scared natural resource. The spectrum owned by the primary…
In this paper, we propose a cooperative approach to improve the security of both primary and secondary systems in cognitive radio multicast communications. During their access to the frequency spectrum licensed to the primary users, the…
Classical beamforming techniques rely on highly linear transmitters and receivers to allow phase-coherent combining at the transmitter and receiver. The transmitter uses beamforming to steer signal power towards the receiver, and the…
The line-of-sight dominant air-ground channels have posed critical interference issues in cellular-connected unmanned aerial vehicle (UAV) communications. In this paper, we propose a new base station (BS) cooperative beamforming (CB)…
In this letter, we consider optimal hybrid beamforming design to minimize the transmission power under individual signal-to-interference-plus-noise ratio (SINR) constraints in a multiuser massive multiple-input-multiple-output (MIMO)…
Fluid antennas (FAs) and movable antennas (MAs) have drawn increasing attention in wireless communications recently due to their ability to create favorable channel conditions via local antenna movement within a confined region. In this…
This paper investigates the problem of resource allocation for multiuser communication networks with a reconfigurable intelligent surface (RIS)-assisted wireless transmitter. In this network, the sum transmit power of the network is…
In this paper, linear beamforming design for amplify-and-forward relaying cellular networks is considered, in which base station, relay station and mobile terminals are all equipped with multiple antennas. The design is based on minimum…
Low-complexity beamformer design with practical constraints is an attractive research area for hybrid analog/digital systems in mm-wave massive multiple-input multiple-output (MIMO). This paper investigates interference-aware pre-beamformer…
This paper presents a two-phase cooperative communication strategy and an optimal power allocation strategy to transmit sensor observations to a fusion center in a large-scale sensor network. Outage probability is used to evaluate the…
In this paper, an optimization framework is proposed for joint transceiver beamforming and admission control in massive MIMO cognitive radio networks. The objective of the optimization problem is to support maximum number of secondary users…
A simple feedback control algorithm is presented for distributed beamforming in a wireless network. A network of wireless sensors that seek to cooperatively transmit a common message signal to a Base Station (BS) is considered. In this…
Detecting weak targets is one of the main challenges for integrated sensing and communication (ISAC) systems. Sensing and communication suffer from a performance trade-off in ISAC systems. As the communication demand increases, sensing…
In this paper, we propose a beamforming design for dual-functional radar-communication (DFRC) systems at the millimeter wave (mmWave) band, where hybrid beamforming and sub-arrayed MIMO radar techniques are jointly exploited. We assume that…
Collaborative beamforming (CB) is a power efficient method for data communications in wireless sensor networks (WSNs) which aims at increasing the transmission range in the network by radiating the power from a cluster of sensor nodes in…
Multibeam technology enables the use of two or more subbeams for joint communication and radio sensing, to meet different requirements of beamwidth and pointing directions. Generating and optimizing multibeam subject to the requirements is…