Related papers: Design of a capacitor-less low-dropout voltage reg…
When electric vehicles (EVs) are integrated into standalone DC microgrids (DCMGs), stability issues arise due to their constant power load (CPL) behavior, which provides negative incremental impedance (NII). In addition, the microgrids…
Modular multilevel converters have promising applications in clean energy, electric vehicles, and biomedical instrumentation, but need many modules to achieve fine output granularity, particularly of the voltage. Asymmetric multilevel…
We implemented a low noise current preamplifier for the readout of resistive bolometers. We tested the apparatus on thermometer resistances ranging from 10 Ohm to 500 Mohm. The use of current preamplifier overcomes constraints introduced by…
We present a current-modulation technique for diode-laser systems that is specifically designed for high-bandwidth laser-frequency stabilization and wideband frequency modulation with a flat transfer function. It consists of a dedicated…
The gain of SiPMs depends both on bias voltage and on temperature. For stable operations, both need to be kept constant. In an ILC calorimeter with millions of channels, this is a challenging task. It is, therefore, desirable to compensate…
The application of multilevel converters to renewable energy systems is a growing topic due to their advantages in energy efficiency. Regarding its control, model predictive control (MPC) has become very appealing due to its natural…
A well-balanced detector with high sensitivity and low noise is presented in this paper. The two-stage amplification structure is used to increase electronic gain while keeping an effective bandwidth of about 70 MHz. In order to further…
Boost, buck-boost, and fly-back DC-DC converters which are utilized in power lines of any electric vehicles, solar energy, and power factor correction applications require control systems to regulate the output voltage under mismatched…
Deep reinforcement learning approaches are becoming appealing for the design of nonlinear controllers for voltage control problems, but the lack of stability guarantees hinders their deployment in real-world scenarios. This paper constructs…
This paper addresses stability issues of DC networks with constant power loads (CPL). Common DC networks, such as automotive electrical systems and DC microgrids, typically have a step-up/down converter connected in one side to the main bus…
Currently, the demand for a better alternative to linear PID controllers is increasing due to the rising expectations of the high-tech industry. In literature, it has been shown that Constant in gain Lead in phase (CgLp) compensators, which…
PI controllers are the most widespread type of controllers and there is an intuitive understanding that if their gains are sufficiently small and of the correct sign, then they always work. In this paper we try to give some rigorous backing…
We consider the problem of voltage stability and reactive power balancing in islanded small-scale electrical networks outfitted with DC/AC inverters ("microgrids"). A droop-like voltage feedback controller is proposed which is quadratic in…
An increasing penetration of renewable energy resources, electric vehicle chargers, and energy storage systems into low-voltage power grids causes several power management and stability problems, such as reverse power flow, (local) overload…
The circuit presented in this paper aims at providing three 40 Vpp 50Hz AC voltages sources with 120-degree phase separation between them. This is a fully analogue circuit that uses standard, low-cost electronic components without resorting…
This paper proposes a novel multilevel inverter for automotive applications. The topology consists of a modular DCDC converter and a tap selector, where the DC-DC converter provides several DC-output levels and the tap selector produces an…
This article is present high precision multiwave rectifier circuit operating in low voltage plus or minus 1.5 Volt current modes by CMOS technology 0.5 \mum, receive input and give output in current mode, respond at high frequency period.…
In this letter, we study the optimal solution of the multiuser symbol-level precoding (SLP) for minimization of the total transmit power under given signal-to-interference-plus-noise ratio (SINR) constraints. Adopting the distance…
The task of this work was to design and later produce a low-power (single supply 5 - 30 V, dual supply +-2.5 V and +-15 V) rail-to-rail operational amplifier aRD820 with low voltage noise (<4 uV, p-p. 0.1 to 10 Hz), ultralow input bias…
Conventional circulators are made of magnetic ferrites and suffer from a cumbersome architecture, incompatibility with integrated circuit technology and inability for high frequency applications. To overcome these limitations, here we…