Related papers: Determination of the characteristics of a linear d…
Estimating the sound absorption in situ relies on accurately describing the measured sound field. Evidence suggests that modeling the reflection of impinging spherical waves is important, especially for compact measurement systems. This…
Noise parameters are a set of four measurable quantities which determine the noise performance of a radio-frequency device under test. The noise parameters of a 2-port device can be extracted by connecting a set of 4 or more source…
Localizing a moving sound source in the real world involves determining its direction-of-arrival (DOA) and distance relative to a microphone. Advancements in DOA estimation have been facilitated by data-driven methods optimized with large…
Sound absorbing materials are usually defined by five parameters: open porosity, static airflow resistivity, tortuosity, and two characteristic lengths. In recent decades, different methods have been developed in order to characterize these…
The identification of sound sources is a common problem in acoustics. Different parameters are sought, among these are signal and position of the sources. We present an adjoint-based approach for sound source identification, which employs…
Sustained oscillations (SOs) are commonly observed in systems dominated by converters. Under specific conditions, even though the origin of SOs can be identified through negative damping modes using conventional linear analysis, utilizing…
A method is presented for the reconstruction of rotating monopole source distributions using acoustic pressures measured on a sideline parallel to the source axis. The method requires no \textit{a priori} assumptions about the source other…
This paper presents a straightforward application of an indirect method based on a three-microphone impedance tube setup to determine the non-acoustic properties of a sound absorbing porous material. First, a three-microphone impedance tube…
The image source method (ISM) is often used to simulate room acoustics due to its ease of use and computational efficiency. The standard ISM is limited to simulations of room impulse responses between point sources and omnidirectional…
We develop a weakly nonlinear model of duct acoustics in two and three dimensions (without flow). The work extends the previous work of McTavish & Brambley (2019, J. Fluid Mech. 875, pp. 411-447) to three dimensions and significantly…
Conventional sound source localization methods are mostly based on a single microphone array that consists of multiple microphones. They are usually formulated as the estimation of the direction of arrival problem. In this paper, we propose…
Acoustic flow velocity and direction meters from the IST series, which can be integrated into various measuring systems, are considered. The simulation of the flow profile in the measuring tube was carried out depending on the free flow…
Quantum noise in a model of singly resonant frequency doubling including phase mismatch and driving in the harmonic mode is analyzed. The general formulae about the fixed points and their stability as well as the squeezing spectra…
This work presents a data-driven approach to estimating the sound absorption coefficient of an infinite porous slab using a neural network and a two-microphone measurement on a finite porous sample. A 1D-convolutional network predicts the…
The intelligent acoustic emission locator is described in Part I, while Part II discusses blind source separation, time delay estimation and location of two simultaneously active continuous acoustic emission sources. The location of…
For extracting a target speaker voice, direction-of-arrival (DOA) estimation is crucial for binaural hearing aids operating in noisy, multi-speaker environments. Among the solutions developed for this task, a deep learning convolutional…
A method for calibrating a monopole sound source in a water tank with reflective side walls and bottom is considered. The idea of the method is based on the phenomenon of anomalous transparency of the water-air boundary for a sound source…
Nonlinear dynamics have long been exploited in order to damp vibrations in solid mechanics. The phenomenon of irreversible energy transfer from a linear primary system to a nonlinear absorber has driven great attention to the optimal design…
The noise of a device under test (DUT) is measured simultaneously with two instruments, each of which contributes its own background. The average cross power spectral density converges to the DUT power spectral density. This method enables…
We present a system for localizing sound sources in a room with several ad-hoc microphone arrays. Each circular array performs direction of arrival (DOA) estimation independently using commercial software. The DOAs are fed to a fusion…