Related papers: CFD Simulation of the NREL Phase VI Rotor
A computational fluid dynamics (CFD) model that solves the steady-state Reynolds-Averaged Navier-Stokes (RANS) equations for buoyant compressible pollution dispersion under different meteorological conditions is developed. A 6.4 km by 6.4…
Computational fluid dynamics (CFD) studies are carried out on a two-bladed vertical axis wind turbine (VAWT) operating at a wind speed of 8 m/s for the tip speed ratios ($\lambda$) of 0.50 - 3.0. The blade consists of the NACA 0021 airfoil…
The purpose of this work is to investigate the flow around a fixed NACA0012 airfoil profile at different angles of attack using wall-resolved LES. The profile has a chord length of c=0.1 m and is exposed to a flow at a Reynolds number of…
The wind tunnel rotary-balance testing is widely used in aircraft dynamics to characterise aerodynamics at moderate and high angles of attack during stall and spin regimes. In such experiments an aircraft test model is rotated along the…
The typical size of computational meshes needed for realistic geometries and high-speed flow conditions makes Computational Fluid Dynamics (CFD) impractical for full-mission performance prediction and control. Reduced-Order Models (ROMs) in…
A numerical simulation method of computational fluid dynamics (CFD) coupling with a trim analysis for coaxial rotor systems is described in this paper. The trim analysis is implemented using a rotorcraft flow solver, rFlow3D. Six target…
Renewable energy has received strong attention and investment to replace fossil energy sources and reduce greenhouse gas emissions. Quite good and good wind speed areas have been invested in building large-capacity wind farms for many…
Aerodynamic noise is a limitation for further exploitation of wind energy resources. As this type of noise is caused by the interaction of turbulent flow with the airframe, a detailed resolution of the flow is necessary to obtain an…
The fluid dynamics video considers an array of two NREL 5-MW turbines separated by seven rotor diameters in a neutral atmospheric boundary layer (ABL). The neutral atmospheric boundary-layer flow data were obtained from a precursor ABL…
Airflow through the nasal cavity exhibits a wide variety of fluid dynamicsbehaviour due to the intricacy of the nasal geometry. The flow is naturallyunsteady and perhaps turbulent, despite CFD in the literature that assumesa steady laminar…
In this paper, investigations are conducted using Reynolds-averaged Navier-Stokes (RANS) turbulence models to investigate the importance of turbulence modelling for nasal inspiration at a constant flow rate of 250 ml/s. Four different,…
Cornerstone of this research is the examination of fluid flow around NACA0012 airfoil, with the aim of the numerical validation between the experimental results in the wind tunnel and the Lattice Boltzmann Method (LBM) analysis, for the…
Sand fences are often erected to reduce wind speed, prevent aeolian soil erosion, and induce sand deposition and dune formation in areas affected by sand encroachment and desertification. However, the search for the most efficient array of…
The meteorological conditions markedly affect the energy efficiencies and cost/power rate of the wind turbines. This study numerically investigates the performance of the National Renewable Energy Laboratory (NREL) Phase VI wind turbine,…
This work presents an investigation on different methods for the calculation of the angle of attack and the underlying induced velocity on wind turbine blades using data obtained from three-dimensional Computational Fluid Dynamics (CFD).…
The aerodynamic performance of an isolated coaxial rotor in forward flight is analyzed by a high-fidelity computational fluid dynamics (CFD) approach. The analysis focuses on the high-speed forward flight with an advance ratio of 0.5 or…
Understanding the flow behavior of complex concentrated slurries is of tremendous importance for industrial waste management. In this study, the transport of three-phase oil sands tailings in a horizontal pipeline is simulated via the…
We present here a computational fluid dynamics (CFD) simulation of Lillgrund offshore wind farm, which is located in the Oresund Strait between Sweden and Denmark. The simulation combines a dynamic representation of wind turbines embedded…
We compare three different methodologies for simulation of turbulent flow past a vertical axis wind turbine: (i) full resolution of the turbine blades in a Direct Finite Element Simulation (DFS), (ii) implicit representation of the turbine…
This paper describes the extensive Wind Tunnel (WT) linear cascade testing campaign carried out on a constant section turbine blade developed for low subsonic applications. Comprehensive experimental program was designed to determine the…