Related papers: Step and Search Control Method to Track the Maximu…
In this work we present a novel dual-port grid-forming control strategy, for permanent magnet synchronous generator wind turbines with back-to-back voltage source converters, that unifies the entire range of functions from maximum power…
This paper presents a combined power system with a common dc bus that contains solar power, wind power, battery storage, and a constant dc load (CDL). In wind system, an AC-DC uncontrolled rectifier is used at the first stage and the DC-DC…
This paper presents design of a Maximum Power Point Tracking (MPPT) circuit and its functionality for tuning the maximum power transfer from an energy harvester (EH) unit. Simple and practical Perturb and Observe algorithm is investigated…
Wind energy is an integral part of nowadays energy supply and one of the fastest growing sources of electricity in the world today. Accurate models for wind energy conversion systems (WECSs) are of key interest for the analysis and control…
This paper proposes a capacitor voltage synchronizing control (CVSC) system for the regulation of full-scale wind power generator-supplied power systems (FWPS). The capacitor combined with the inverter of a full-scale wind power generator…
A Z-source inverter based grid-interface for a variable-speed wind turbine connected to a permanent magnet synchronous generator is proposed. A control system is designed to harvest maximum wind energy under varied wind conditions with the…
In this paper, we deal with the power regulation of tethered-wing systems and demonstrate advantages of variable-pitch control in mitigating the dynamic mechanical loads and power fluctuations. The proposed scheme is based on a strategy…
Wind turbine (WT) controllers are often geared towards maximum power extraction, while suitable operating constraints should be guaranteed such that WT components are protected from failures. Control strategies can be also devised to reduce…
A revised Incremental Conductance (IncCond) maximum power point tracking (MPPT) algorithm for PV generation systems is proposed in this paper. The commonly adopted traditional IncCond method uses a constant step size for voltage adjustment…
This chapter provides an introduction to the modeling and control of power generation from wind turbine systems. In modeling, the focus is on the electrical components: electrical machine (e.g. permanent-magnet synchronous generators),…
This paper presents a sensor-less maximum power tracking (MPT) pitch controller for grid connected Wind Turbine (WT). The main advantage of the proposed architecture is that the approach ensures smooth operation and thus minimizes the…
Modern power systems are characterized by low inertia and fast voltage dynamics due to the increase of sources connecting via power electronics and the removal of large traditional thermal generators. Power electronics are commonly equipped…
Extracting maximum power available from photovoltaic arrays requires the system operating at the maximum power point (MPP). Therefore, finding the MPP is necessary for efficient operation of PV arrays. The MPP changes with multiple…
Using Photovoltaic systems is gradually expanded by increasing energy demand. Abundance and availability of this energy, has turned to one of the most important sources of renewable energy. Unfortunately, photovoltaic systems have two big…
Wind energy conversion system (WECS) is stochastic in nature and has low inertia to grid voltage instability, poor reactive power compensation and most importantly fault susceptibility. Variable speed WECS such as a doubly-fed induction…
The dynamic security assessment of power systems needs to scan contingencies in a preselected set through time-domain simulations. With more and more inverter-based-generation, such as wind and solar power generation, integrated into power…
Airborne wind energy systems aim to generate renewable energy by means of the aerodynamic lift produced by a wing tethered to the ground and controlled to fly crosswind paths. The problem of maximizing the average power developed by the…
Power electronic converters enable wind turbines, operating at variable speed, to generate electricity more efficiently. Among variable speed operating turbine generators, permanent magnetic synchronous generator (PMSG) has got more…
Power-to-gas (P2G) can be employed to balance renewable generation because of its feasibility to operate at fluctuating loading power. The fluctuating operation of low-temperature P2G loads can be achieved by controlling the electrolysis…
The current paper presents a Sliding Mode Controller (SMC) for indirect field-oriented Cascaded Doubly Fed Induction Generator (CDFIG) powered through a Matrix Converter (MC). The proposed SMC employs a continuous control strategy to…