Related papers: A new inner drift chamber for BESIII MDC

Resistive-wall impedance usually constitutes a significant percentage of the total beamcoupling impedance budget of an accelerator. Reduction techniques often entail high electrical-conductivity coatings. This paper investigates the use of…

The Monitored Drift Tube (MDT) chambers for the muon spectrometer of the ATLAS detector at the Large Hadron Collider (LHC) consist of 3-4 layers of pressurised drift tubes on either side of a space frame carrying an optical deformation…

In this work, salient characteristics of a wireless communication system deploying a great number of antennas in the base station (BS), namely Massive MIMO system, are investigated. In particular, we found a simple and meaningful…

A new adaptive receiver design for the Multicarrier (MC) DS-CDMA is proposed employing successive interference cancellation (SIC) architecture. One of the main problems limiting the performance of SIC in MC DS-CDMA is the imperfect…

Ultra-thin metallic anodic and cathodic wires are frequently employed in low-mass gaseous detectors for precision experiments, where the amount of material crossed by charged particles must be minimised. We present here the results of an…

In this paper, we investigate a multi-cell six-dimensional movable antenna (6DMA) network for enhancing downlink communication performance under inter-cell interference (ICI). Each base station (BS) is equipped with multiple 6DMA surfaces,…

The application of multilevel converters to renewable energy systems is a growing topic due to their advantages in energy efficiency. Regarding its control, model predictive control (MPC) has become very appealing due to its natural…

For precise start time determination a Beam Fragmentation T$_0$ Counter (BFTC) is under development for the Time-of-Flight Wall of the Compressed Baryonic Matter Spectrometer (CBM) at the Facility for Antiproton and Ion Research (FAIR) at…

This paper proposes a novel metamaterial-inspired absorber designed to enhance the data rate in 52% RF to DC conversion simultaneous wireless information and power transfer system (SWIPT) through biological tissue. The proposed absorber…

We present the development of the FBCM23 ASIC designed for the Phase-II upgrade of the Fast Beam Condition Monitoring (FBCM) system built at the CMS experiment which will replace the present luminometer based on the BCM1F ASIC [1]. The FBCM…

A fundamental limit to the application of Time Projection Chambers (TPCs) in high-rate experiments is the accumulation of slowly drifting ions in the active gas volume, which compromises the homogeneity of the drift field and hence the…

This paper studies a two-layer decoding method that mitigates inter-cell interference in multi-cell Massive MIMO systems. In layer one, each base station (BS) estimates the channels to intra-cell users and uses the estimates for local…

Cell-Free Massive MIMO comprises a large number of distributed single-antenna access points (APs) serving a much smaller number of users. There is no partitioning into cells and each user is served by all APs. In this paper, the uplink…

An acoustic negative bulk modulus metamaterial based on the concept of expansion chambers is proposed. It is shown that addition of a neck region to an ordinary expansion chamber improves its transmission loss characteristics at low…

After the successful installation and first operation of the new Inner Tracking System (ITS2), which consists of about 10 m$^2$ of monolithic silicon pixel sensors, ALICE is pioneering the usage of bent, wafer-scale pixel sensors for the…

We consider the multi-cell uplink (network MIMO) where M base-stations (BSs) communicate simultaneously with M user terminals (UTs). Although the potential benefit of multi-cell cooperation increases with M, the overhead related to learning…

We use stochastic network calculus to investigate the delay performance of a multiuser MISO system with zero-forcing beamforming. First, we consider ideal assumptions with long codewords and perfect CSI at the transmitter, where we observe…

This paper describes the calibration procedure for the drift tubes of the CMS barrel muon system and reports the main results obtained with data collected during a high statistics cosmic ray data-taking period. The main goal of the…

Analog-to-digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) communication systems with large number of antennas. Use of low resolution ADCs has been proposed as a means to…

The aging effects of a 'diffusing glass', a single elastic string diffusing in a two-dimensional disordered media assisted by thermal noise are studied by Monte Carlo (MC) simulations. We find for the first time convincing numerical…