Related papers: Lup-Like Cantilever Beam for Small Deflection
The dynamics of a cantilever plate clamped at its trailing edge and placed at a moderate angle ($\alpha \leq 30^{\circ}$) to a uniform flow are investigated experimentally and numerically, and a large experimental data set is provided. The…
This paper addresses the challenges of the Euler-Bernoulli beam theory regarding shortening and stretching assumptions. Certain boundary conditions, such as a cantilever with a horizontal spring attached to its end, result in beams that…
Conical refraction occurs when a beam of light travels through an appropriately cut biaxial crystal. By focussing the conically refracted beam through a high numerical aperture microscope objective, conical refraction optical tweezers can…
We consider a beam model representing the transverse deflections of a one dimensional elastic structure immersed in an axial fluid flow. The model includes a nonlinear elastic restoring force, with damping and non-conservative terms…
Designing materials or structures that can achieve asymmetric shape-shifting in response to symmetrically switching stimuli is a promising approach to enhance the locomotion performance of soft actuators/robots. Inspired by the geometry of…
Lighter-than-air vehicles or blimps, are an evolving platform in robotics with several beneficial properties such as energy efficiency, collision resistance, and ability to work in close proximity to human users. While existing blimp…
Modern advances in polarized beam control should make it possible to accurately measure Stern-Gerlach (S-G) deflection of relativistic beams. Toward this end a relativistically covariant S-G formalism is developed that respects the opposite…
A pinned-free beam in axial fluid flow, subjected to feedback-based actuation at the pinned end, is investigated. The actuation may be a moment or a prescribed angle and it is proportional to the state (curvature, slope, or displacement) of…
Following Sereno (2002a), we discuss the bending of light rays by spherically symmetric lenses with angular momentum. For several astrophysical systems, such as white dwarfs and galaxies, gravitomagnetism induces a correction on the…
In this paper, we consider an imperfect finite beam lying on a nonlinear foundation, whose dimensionless stiffness is reduced from $1$ to $k$ as the beam deflection increases. Periodic equilibrium solutions are found analytically and are in…
In optical detection setups to measure the deflection of micro-cantilevers, part of the sensing light is absorbed, heating the mechanical probe. We present experimental evidences of a frequency shift of the resonant modes of a cantilever…
The undulator is a critical component to produce synchrotron radiation and free electron laser. When a Bessel light beam carrying the orbit angular momentum co-propagates with an electron beam, a net transverse deflection force will be…
Continuum robots are well suited for constrained environments but suffer from low distal stiffness, resulting in large posture errors under external loads. In this paper, we propose a novel structural primitive, the Distal-Stable Beam,…
Curving beams are a promising new method for bypassing obstacles in future millimeter-wave to sub-terahertz (sub-THz) networks but lack a general predictive model for their reflections from arbitrary surfaces. We show that, unfortunately,…
The generation of ultra-relativistic positron beams with short duration ($\tau_{e^+} \leq 30$ fs), small divergence ($\theta_{e^+} \simeq 3$ mrad), and high density ($n_{e^+} \simeq 10^{14} - 10^{15}$ cm$^{-3}$) from a fully optical setup…
While most strong-gravitational-lensing systems may be roughly modelled by a single massive object between the source and the observer, in the details all the structures near the light path contribute to the observed images. These…
Dissipative optomechanics has some advantages in cooling compared to the conventional dispersion dominated systems. Here, we study the optical response of a cantilever-like, silica, microsphere pendulum, evanescently coupled to a fiber…
The purpose of this paper is to apply characteristics of residual stress that causes cantilever beams to bend for manufacturing a micro-structured gas flow sensor. This study uses a silicon wafer deposited silicon nitride layers,…
It is well known that magnetic energy of the piezoelectric beam is relatively small, and it does not change the overall dynamics. Therefore, the models, relying on electrostatic or quasi-static approaches, completely ignore the magnetic…
We consider the lateral shift of a light beam reflecting from a dielectric slab backed by a metal. It is found that the lateral shift of the reflected beam can be negative while the intensity of reflected beam is almost equal to the…