Related papers: Full-Duplex Transceiver System Calculations: Analy…
In future B5G/6G broadband communication systems, non-linear signal distortion caused by the impairment of transmit power amplifier (PA) can severely degrade the communication performance, especially when uplink users share the wireless…
Low-resolution analog-to-digital converters (ADCs) in massive multi-user (MU) multiple-input multiple-output (MIMO) wireless systems can significantly reduce the power, cost, and interconnect data rates of infrastructure basestations. Thus,…
In the uplink of a cell-free massive MIMO system, quantization affects performance in two key domains: the time-domain distortion introduced by finite-resolution analog-to-digital converters (ADCs) at the access points (APs), and the…
Nonlinear self-interference (SI) cancellation is essential for mitigating the impact of transmitter-side nonlinearity on overall SI cancellation performance in flexible duplex systems, including in-band full-duplex (IBFD) and sub-band…
High resolution analog to digital converters (ADCs) are conventionally used at the receiver terminals to store an accurate digital representation of the received signal, thereby allowing for reliable decoding of transmitted messages.…
Full-duplex systems require very strong self-interference cancellation in order to operate correctly and a significant part of the self-interference signal is due to non-linear effects created by various transceiver impairments. As such,…
Power amplifiers (PA) are essential for microwavecontrolled trapped-ion and semiconductor spin based quantum computers (QC). They adjust the power level of the control signal and therefore the processing time of the QC. Their nonlinearities…
Incorporating full duplex operation in Multiple Input Multiple Output (MIMO) systems provides the potential of boosting throughput performance. However, the hardware complexity of the analog self-interference canceller in emerging full…
We consider a wideband integrated access and backhaul system operating in full-duplex mode between the New Radio gNB donor and single user equipment. Due to high power consumption in millimeter wave systems, we use low-resolution…
Imperfections in analog-to-digital conversion (ADC) cannot be ignored when signal digitization requirements demand both wide dynamic range and high resolution, as is the case for the Majorana Demonstrator 76Ge neutrinoless double beta decay…
In this paper, we analytically study the regime in which practical full-duplex systems can achieve larger rates than an equivalent half-duplex systems. The key challenge in practical full-duplex systems is uncancelled self-interference…
In large-scale antenna systems, using one-bit analog-to-digital converters (ADCs) has recently become important since they offer significant reductions in both power and cost. However, in contrast to high-resolution ADCs, the coarse…
Low-resolution digital-to-analog and analog-to-digital converters (DACs and ADCs) have attracted considerable attention in efforts to reduce power consumption in millimeter wave (mmWave) and massive MIMO systems. This paper presents an…
In carrier-aggregation systems, digital baseband cancelation of self-interference generated by receiver nonlinearity requires the estimation of several reference signals contributions. As the nonlinearity order and frequency selectivity of…
A novel background calibration technique for Time-Interleaved Analog-to-Digital Converters (TI-ADCs) is presented in this paper. This technique is applicable to equalized digital communication receivers. As shown by Tsai et al. [1] and Luna…
Nonlinear distortion stemming from low-cost power amplifiers may severely affect wireless communication performance through out-of-band (OOB) radiation and in-band distortion. The distortion is correlated between different transmit antennas…
The cell-free integrated sensing and communication (CF-ISAC) architecture is a promising enabler for 6G, offering spectrum efficiency and ubiquitous coverage. However, real deployments suffer from hardware impairments, especially nonlinear…
Real-world wireless transmitter front-ends exhibit certain nonlinear behavior, e.g., signal clipping by a Power Amplifier (PA). Although many resource allocation solutions do not consider this for simplicity, it leads to inaccurate results…
The fundamental problem in the design of a full-duplex radio is the cancellation of the self-interference (SI) signal generated by the transmitter.Current techniques for suppressing SI rely on generating a copy of the SI signal and…
We investigate full-duplex (FD) multi-user multiple input single-output systems with coarse quantization, aiming to characterize the impact of employing low-resolution analog-to-digital converters (ADCs) on self-interference (SI) and to…